Height Adjustment - Palazzetti ECOMONOBLOCCHI Instrucciones De Uso

5 mm
2 m
34
5 mm
- 6.3a -
5 mm
0, 5 cm
B
B
A
- 6.3b -
A
0,4 m
- 6.4 -
INSTALLATION
6.2 EARTHING
The Ecomonoblocco is equipped with a screw for the
equipotential connection which can hold a cable with a
section from 2.5 mm
equipotentiality of the earth in compliance with current
Ecomonoblocco and is indicated by the symbol
to the standards in force.
6.3

HEIGHT ADJUSTMENT

on the base. Adjsut the screws
the Ecomonoblocco is at the proper height compared to
adjustment screws. Where featured, the lever for the
adjustment of combustion air must be about 0.5 cm over
the cladding surface, so that it is easily usable. (Fig. 6.3b).
6.4 SMOKE EXHAUST SYSTEM
The Ecomonoblocco must be connected to a smoke
exhaust system so as to ensure combustion products are
suitably discharged into the atmosphere, in accordance
with standards EN 1856-1-2 EN 1857, EN 1443 EN
13384-1-3, EN 12391-1 and UNI 10683, both as regards
sizing and the construction materials used.
The CHIMNEY must be sized as described on the
datasheet (average draught 12 Pa with door closed).
The components making up the combustion
product exhaust system must be declared as being
marked (declaration of conformity or European
technical approval for the product).
its entire height.
The minimum recommended height is 3.5 to 4 m
(Fig. 6.4).
A collection chamber should be featured at the bottom of
illegal and affect correct operation of the Ecomonoblocco.
A PERFECT DRAUGHT
that is clear of obstructions such as chokes, horizontal
sections or corners; any axial displacements should be
at a maximum angle of 45° compared to the vertical axis,
(better still if it is only 30°). These displacements should
preferably be effected near the chimney top (Fig. 6.5).
The SMOKE
direction in respect to the smoke outlet of the appliance
must be executed using elbows not exceeding 45° in
respect to vertical.
The CHIMNEY TOP shall be the WINDPROOF type
with an inside cross section equivalent to that of the
cod. 004771651 MBL - 10/2015 - Palazzetti - PN - Italy
2 to 6 mm 2 , to be used to obtain
.