VOLTWERK VS 3 Instrucciones De Servicio página 94

Voltwerk VS 3, 4, 5
Required tools and materials
| Cable stripper
| Phillips screwdriver (PZ1)
| Mains plug (included in the delivery)
| For wire cross-section up to 6 mm
When doing so, make sure that the AC line is protected by
a fuse of max. 32 A.
| For cable diameters of 13–18 mm
Connecting the power cable
1. Strip the cable to 35 mm.
Sachschaden durch beschädigte Litzen!
Beschädigte Litzen können brechen und sich erhitzen.
| Litzen nicht beschädigen.
2. Strip wires to 9 mm.
3. Guide the cable through the housing of mains plug (1).
The contact screws on the end piece (2) are designed for
flexible wires without cable end sleeves.
Risk of injury due to electrical hazards
When commissioning, the electrical system may still present
a hazard despite careful installation and compliance with the
basic safety instructions. These hazards include:
| Direct contact with electrically live system components
| Electrostatic processes
| Short circuits and overloading
Operating manual
5 Installation
2
31