Animal Weighing - OHAUS Adventurer Pro AV53 Manual De Instrucciones

Adventurer Pro
3.5.4 Check Weighing (Cont.)
Editing Limits
The limits are edited one digit at a time. The
digit being edited is blinking. Its value can be
incremented by pressing the No button or
decremented by pressing the Back button.
When the desired value is displayed, press the
Yes button to accept the value and proceed to
the next digit. When all digits have been edited,
the new limit value is shown (blinking) on the
secondary display. Press the Yes button to
accept the new limit value or the No button to
edit the limit value. When editing of the Over
limit is complete, Check Weighing begins.
Checkweighing
Place the sample on the pan. The UNDER/
ACCEPT/OVER status is shown on the primary
display while the actual weight of the item is
shown on the secondary display.

3.5.5 Animal Weighing

Enter this mode to weigh unstable loads such as a moving animal. Refer to paragraph 3.4.3 to
enable Animal Weighing.
USE
The balance alternately shows READY and
ANIMAL on the secondary display.
Start Animal Cycle
Automatic and Semi-Automatic Mode
The animal cycle begins when an animal is
placed on the pan.
Manual Mode
The animal cycle begins when the Function
button is pressed.
During Animal Cycle
The primary display shows the countdown from
the level setting (5, 10 or 15 seconds) to AWO.
The secondary display alternately shows
ANIMAL and BUSY.
EN-15