Dea NET24N Instrucciones De Uso Y Advertencias página 44

5
Selection of direction of motion
1. Scroll down the parameters with
until you visualise P063;
2. Access the parameter by pressing the
3. Acting on and
- d000=motor in standard position (on the left of
the gap);
- d001=motor in inverted position (on the right of
the gap);
4. Confirm your choice by pressing the
returns again to P063).
6
Motor stroke learning
1. Scroll down the parameters with
2. Access the parameter by pressing the
3. When " " flashes, continue pressing the
4. Release the key when "
5. Wait for the door searches and stops on the opening stop and then on the closing stop.
If you want to anticipate the stopping strokes in opening, you can manually intervene by giving an impulse to "Start" button
(or pressing the "OK" on the control panel) simulating the stroke.
6. Once the procedure is ended, the display will show "----".
7
Transmitters learning
7.1 Transmitters coding selection
1. Scroll down the parameters with
sualise P027;
2. Confirm by pressing on the
3. Select the type of transmitter by scrolling
- d000=fix rolling-code (suggested);
- d001=complete rolling-code;
- d002=dip-switch;
4. Confirm by pressing on the
Warning: If you need to vary the type of encoding, and only
if other remotes with different encoding are memorized, you
need to erase memory (P004) AFTER you have set the new
encoding.
42
and keys
key;
keys, set:
key (display
and keys until you visualise P003;
key;
key;
" stops flashing; the learning procedure starts;
and keys until you vi-
key;
and
key (display shows again P027).
keys: