vivitta vin 906 Manual De Instrucciones página 11

2. uses in the vehicle
Where:
in the vehicle rear seats.
Please, do NoT install the safety seat in
forward seats except for the following
cases:
1. whenever the vehicle does not count
with rear seats.
2. when all rear seats are already occupied
by children exceeding 135 cm height.
3. when it is not possible to install all child
restraints systems in the rear seats.
cÓMo:
GRUPo 0/ install rearward facing.
GRUPo 1 / install forward facing.
GRUPo 2-3 / install forward facing.
(vehicle's 3 point belt).
notice
The child seat must only be used in this
seat iF it has a lap and diagonal belt (3
points).
20
a
a
b
1
b
1
2
2
The seat offers a number of assembly options. The
3 point belt.
following table shows the installation types for each
—
2 point belt. group:
seat
Diagonal belt GrouP
installation
section.
Abdominal belt
section.
0+ (0-13 kg) 3 point belt
1 (9-18 kg) 3 point belt
2 (15-25 kg) 3 point belt
3 (22-36 kg)
3 point belt
3. general seat use
3.1. how to use the harness buckle
1. Bring the two clasps together (fig.1.1).
2. Make sure the correct side is facing up (fig.1.2).
3. Fasten the two clasps together before inserting
them into the harness buckle. You should hear a
click (fig.1.3).
4. Pull the harness adjustment belt
part of the strap that covers the lap is not loose,
ensuring the harness is taut and the buckle closed.
open the harness buckle
button (fig.1.4).
cHild manual
installation cHaPter
fig. 1
1
5 point
safety 4
harness
5 point
safety 6
harness
3
Vehicle´s
8
belt
Vehicle´s
8
belt
3.2. harness buckle care
in order to ensure child safety it is essential that
the harness works correctly. if this is not the case
it is probably because of an accumulation of dirt or
foreign bodies.
incorrect operation is understood as:
• The buckle clasps are notably slow to release
when the red button is pressed.
• The buckle clasps cannot be inserted (they fall out
when they are inserted into the buckle).
(14) so that the
(7) by pressing the red
2
4
21