Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4. car seat installation. grouP 0+
GROUP 0 only. From 0 to 12
notice
months approx. (0 - 13 kg).
1. Make sure the 5-point harness of the safety seat
has been correctly installed (see section 3).
2. Follow the steps described in section 3.1.
3. Follow the steps described in points 3.8 and 3.9
4. Recline the seat fully. Pull the lever
(15)
and adjust the angle of recline to position 4
without releasing the lever. Release the lever when
the seat is in the desired position (fig. 11)
5. Place the seat in the back seat of the vehicle and
contrary to the direction of travel (fig. 12).
6. Take out the reducer cushion (4). Pass the
abdominal strap of the seat belt through the
lower seat guides
(11)
and underneath the seat.
Buckle the vehicle seat belt until you hear a click
(fig. 13).
7. Pass the abdominal strap of the seat through the
upper guides
(16)
as shown in fig. 14.
8. Take up the remaining slack of the diagonal section
of the 3-point seat belt (fig. 14). and make sure it
is as tight fitting as possible. Ensure the straps are
not twisted or knotted at any point.
9. Place the reducer cushion in his original place.
10. Follow the steps in section 6, securing the child
with the 5-point harness.
26
fig. 11
1 2 3
4
forward
(11)
Abdominal
fig. 13
belt guides
(group
0/1/2/3).
11
click
(16)
Diagonal
belt guide
(group 0).
5. Placing the child in the seat. grouP 0
fig. 12
TIP: The more snugly the harness fits over the
child's body, the better the child will be protected.
therefore avoid putting thick clothes on your child
under the belt.
1. Release the harness buckle
2. Press the harness adjuster button
pulling the part of the harness straps that cross
the chest in order to loosen them fig. 2). Do not
pull the shoulder protectors.
3. Place the child in the safety seat.
4. Make sure the child's back rests firmly against the
back of the safety seat.
11
5. Bring the two clasps together
before inserting them into the harness buckle (7).
You should hear a click (fig. 16).
6. Pull the harness adjustment strap
tighten and adjust it correctly to the child's body
(fig. 17).
fig. 14
IMPORTANT! The part of the belt the crosses the
abdomen should be placed as low as possible on the
child's hip.
16
7. Pull down on the shoulder protectors
ensure they are properly in place.
fig. 15
(7)
(fig. 15).
(13)
while
(14)
Harness
adjust
strap.
(5)
and join them
(14)
in order to
(3)
to
fig. 16
click
fig. 17
14
27
Publicidad
Tabla de contenido
