Removing The 5-Point Harness; Removing The Cover - vivitta vin 906 Manual De Instrucciones

• The buckle clasps come together without making a
click.
• It becomes difficult to insert the clasps into the
buckle (resistance is felt).
• The buckle only opens when forced.
3.3. solution
Clean the harness buckle so that it works properly.
3.4. cleaning the harness buckle
1. open the buckle (press the red button).
(24)
2. Hold the metal plate from below in a vertical
position.
(24)
3. Slide the metal plate along the slot.
4. Remove the buckle (7).
(7)
5. Steep the buckle in hot water and neutral liquid
detergent for at least one hour. Rinse and dry it.

3.5. removing the 5-point harness

1. Loosen the harness straps by pulling them at the
point where they cover the chest while pressing
the harness adjustment button (13) (fig.2).
2. Locate the harness strap connector
unclip the harness straps, freeing them from the
connector, then remove them by pulling them
from the front of the seat (fig. 3 and 4).
3. Free the shoulder protectors (3) by unfastening
them from the connector that joins them (located
at the back of the seat) or, in the event they are
22
joined without a connector, by passing them directly
through the corresponding holes in the seat.
(13) Harness
fig. 2
adjustment
button.
(18)
Harness
fig. 3
strap
connector
(19) Shoulder
pads
(18) and
connector
fig. 4
13
4. Turn the seat over and, from the back, free the
belt buckle (7) by passing the retention plate
through the slot in the seat (fig. 6).
5. Remove the belt buckle and save it in the
storage bag.
6. Take out the harness straps retention plates
(22)
located in the bottom of the seat, under the
plastic white plate by pulling the strap, take it out
(24) (fig. 5).
19
7. Take off the harness straps by pulling them out of
the seat.
18
fig. 5 fig. 6
22 22
23

3.6. removing the cover

(24)
A) Headrest.
1. Adjust the headrest to its highest position.
2. First remove the part of the cover that includes the
(2)
safety belt guide followed by the remainder of
the headrest cover.
B) To remove the 5-point harness, see point 3.5.
Remove the back and base covers.
3.7. Putting the cover back on
Follow the same steps in reverse order.
IMPORTANT! Never use the safety seat following
the installation instructions described in point 5
without having a correctly installed buckle. Make
(24)
sure the metallic plate
24
is properly secured.
23