Installation; Fit The Dust Cover - Technics SL-1200GR Instrucciones De Funcionamiento

Install the unit on a horizontal surface
protected from vibrations.
Keep this unit as far as possible from speakers.
 
Adjusting the height to make the
unit horizontal
Increases
the height
Raise the main unit to turn the insulators and
adjust the height.
 Clockwise: Reduces the height.
 Anti-clockwise: Increases the height.
Attention
 Do not turn the insulators too far.
Doing so may cause them to come off or
damage them.

Fit the dust cover

1
Hold the dust cover with both
hands and insert it into the dust
cover fitting parts (  11) on the
player.
 To remove the dust cover, keep it open
and lift it straight above.
Attention
 Return the tone arm to the arm rest and fix
it with the arm clamp before you attach or
detach the dust cover.
 When inserting the dust cover, prevent the tip
of the hinges from hitting and damaging the
main unit.

Installation

 
Notes for installation
 Before you move the unit, remove all devices
connected and turn off the power supply.
 Ensure the unit is not exposed to direct
sunlight, dust, humidity, and heat from a
heating appliance.
 This unit may pick up interference from a
radio if there is one nearby.
Keep the unit as far as possible from a radio.
 Do not install the unit on a heat source.
 Avoid a place with large temperature variations.
 Avoid a place with frequent condensation.
 Avoid an unstable place.
 Do not put an object on the unit.
Reduces
 Do not install the unit in a confined space
the height
such as a book shelf.
 Install the unit at a position well away from
walls or other devices to ensure effective
heat radiation from the inside of the unit.
 Make sure that the material of the
installation location is sufficiently strong to
withstand the weight of this unit.
 Note that the unit may be damaged by
cigarette smoke or moisture from an
ultrasonic humidifier.
 
Condensation
Think of taking out a cold bottle from a
refrigerator. If you leave it in a room for a while,
dewdrops will form on the bottle surface.
This phenomenon is called "condensation".
 Conditions causing condensation
 Rapid temperature change (caused by
moving from a warm place to a cold place or
vice versa, rapid cooling or heating, or direct
exposure to cooled air)
 High humidity in a room with much steam,
etc.
 Rainy season
 Condensation may damage the unit. If it
has occurred, turn the unit off and leave it
until it adapts to the ambient temperature
(approximately 2 to 3 hours).
17
(17)
English