Resolution Of Problems And Questions - I-Tech SMART TENS Manual Del Usuario

8. Resolution of problems and questions.

Any type of work on SMART TENS must be carried out exclusively by the manufacturer
or by an authorised dealer. In any event, any presumed malfunction of SMART TENS
must be verified before sending the device to the manufacturer.
Here below are some typical situations:
SMART TENS cannot be turned on:
 Check batteries status (if possible) and eventually substitute them (see chapter 6).
 Check the proper closing of battery compartment (SMART TENS has a safety control
and does not permit the use with battery compartment opened).
 Check that the ON/OFF button has been pressed correctly (held down for at least one
second).
SMART TENS does not transmit electric impulses:
 Check that the cable jacks have been inserted in the electrodes and that the plastic
protection has been removed from the electrode.
 Check that the cables have been connected correctly (connector well inserted in the
device).
 Check the electrodes status: damage or poor quality electrodes cannot properly
transmit electrical impulses. Substitute the electrodes if necessary.
Warning: SMART TENS has a safety output control to check the correct connection of
cables and electrodes, and also the correct transmission of the current to the patient. In
case of uncorrect connection is not possible to exceed 9mA intensity: SMART TENS
will stop erogation and return to main screening.
Check cables and electrodes status (eventually substitute them) and the correct
conncetion to the patient. If the problem persists contact the manufacturer.
SMART TENS switches off during operation:
 We recommend to substitute the batteries (see chapter 6) and restart the treatment. If
the problem persists contact the manufacturer
Disposal
To protect the environment, the device, its accessories and above all the batteries must
be disposed of in areas equipped for that purpose or as special waste.
Product subject to WEEE regulations concerning separate waste collection: when
disposing this product, please use the designated areas for disposing electronic waste
or contact the manufacturer.
I.A.C.E.R. S.r.l. 33 MNPG45-02