Important; Fcc Caution - Yamaha YAS-106 Manual De Instrucciones

FCC INFORMATION (for US customers)
1
IMPORTANT NOTICE: DO NOT
MODIFY THIS UNIT!: This product,
when installed as indicated in the
instructions contained in this manual,
meets FCC requirements.
Modifications not expressly approved
by Yamaha may void your authority,
granted by the FCC, to use the product.
2 IMPORTANT: When connecting this
product to accessories and/or another
product use only high quality shielded
cables. Cable/s supplied with this
product MUST be used. Follow all
installation instructions. Failure to
follow instructions could void your
FCC authorization to use this product
in the USA.
3 NOTE: This product has been tested
and found to comply with the
requirements listed in FCC
Regulations, Part 15 for Class "B"
digital devices. Compliance with these
requirements provides a reasonable
level of assurance that your use of this
product in a residential environment
will not result in harmful interference
with other electronic devices. This
equipment generates/uses radio
frequencies and, if not installed and
used according to the instructions
found in the users manual, may cause
interference harmful to the operation of
other electronic devices.
This device complies with Part 15 of FCC Rules and Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of this device.
4 Compliance with FCC regulations does
not guarantee that interference will not
occur in all installations. If this product
is found to be the source of
interference, which can be determined
by turning the unit "OFF" and "ON",
please try to eliminate the problem by
using one of the following measures:
5 Relocate either this product or the
device that is being affected by the
interference.
6 Utilize power outlets that are on
different branch (circuit breaker or
fuse) circuits or install AC line filter/s.
7 In the case of radio or TV interference,
relocate/reorient the antenna. If the
antenna lead-in is 300 ohm ribbon lead,
change the lead-in to coaxial type
cable.
8 If these corrective measures do not
produce satisfactory results, please
contact the local retailer authorized to
distribute this type of product. If you
can not locate the appropriate retailer,
please contact Yamaha Corporation of
America A/V Division 6600
Orangethorpe Ave., Buena Park, CA
90620.
9 The above statements apply ONLY to
those products distributed by Yamaha
Corporation of America or its
subsidiaries.

FCC CAUTION

Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTICE
• This equipment compiles with FCC/IC radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines
and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low
levels of RF energy that it deemed to comply without maximum permissive exposure
evaluation (MPE). But it is desirable that it should be installed and operated with at least 20
cm and more between the radiator and person's body.
• This transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.
3
En