Using The Battery Pack; Attaching The Battery Pack; Removing The Battery Pack - Nikon MB-D10 Manual Del Usuario

Using the Battery Pack

Attaching the Battery Pack

Attaching the Battery Pack
Before attaching the battery pack, be sure that the camera is off and that the MB-D10 control lock
En
(Figure A- ) is in the L position (the illustrations show the D300).
1 Remove the contact cap (Figure A- ) from the battery pack.
2 The contacts for the MB-D10 are in the base of the camera, where they are protected by a con-
tact cover. Remove the contact cover as shown in Figure B-
holder on the MB-D10 (Figure B- ).
3 Insert the MB-D10 (Figure C), keeping the MB-D10 mounting screw (C- ) aligned with the
camera tripod socket (C- ). There is no need to remove the battery from the camera before
connecting the MB-D10. At default settings, the battery inserted in the camera will be used
only after the battery in the MB-D10 is exhausted. The [Battery order] option in the camera
Custom Settings menu (Group d) can be used to change the order in which the batteries are
used. See the camera manual for details.
4 Tighten the attachment wheel by rotating it in the direction shown by the LOCK arrow (Figure
D).
Be sure to place the camera contact cover in the contact cover holder to prevent loss.
A PB-6D and PK-13 auto-extension ring are required when using PB-6 bellows with the MB-D10.
6
and place it in the contact cover

Removing the Battery Pack

Removing the Battery Pack
To remove the MB-D10, turn the camera off
and set the control lock on the MB-D10 to L,
then loosen the attachment wheel and re-
move the MB-D10. Be sure to replace the con-
tact cover on the camera and the contact cap
on the MB-D10 when the battery pack is not
in use.