Change Engine Oil - ENAR ZEN SERIE Manual De Instrucciones

7.4 CHANGE ENGINE OIL

HONDA MOTOR:
7.4.1.
7.4.2.
7.4.3.
7.4.4.
7.4.5.
HATZ MOTOR:
7.4.6.
7.4.7.
7.4.8.
7.4.9.
To check the oil level, remove the dipstick, clean off, replace screwing back the plug and finally take
it out again and check the level on the dipstick. Where necessary, refill up to the maximum level.
VIBRATING PLATES
Drain the oil when the engine is still lukewarm to make it easier to empty it quickly and
completely.
Unscrew the filling cap and the drainage cap and empty the oil into a container.
Screw the drainage cap tightly on.
Add the recommended oil to level (see point 4.1 ENGINE DAT)
Screw on the filling cap.
Place a receptacle underneath the motor to collect the oil.
Remove the drain plug and wait until all the oil has drained out.
Clean the drain plug, fit a new washer and tighten up again (50Nm).
Add engine oil. (see section on technical specifications)
OILCAP/DIPSTICK
LEVEL
DRAINAGE CAP
Hatz motor
ZEN / ZEN-E
en
21