Operation Of The Machine; In The Case Of Faults; Instructions For Ordering Spare Parts; Instructions For Requesting Guarantees - ENAR ZEN SERIE Manual De Instrucciones

OPERATION OF THE MACHINE

8

IN THE CASE OF FAULTS

8.1 INSTRUCTIONS FOR ORDERING SPARE PARTS

en
1.
2.
3.
4.

8.2 INSTRUCTIONS FOR REQUESTING GUARANTEES

1.
2.
3.
4.
5.
NOTE: ENARCO, S.A. reserves the right to modify any information in this manual without prior notification.
30
ZEN / ZEN-E
Slow transition speed and weak vibration.
Skewed movement

Insufficient engine power

The clutch slips

V-belt slips

Excessive vibrator oil

Internal parts of vibrator faulty
Does not advance

V-belt uncoupled or slips

Clutch slips

Vibrator caught

If it vibrates but does not move, the vibrator may be on a wet and
slippery surface. Try on the correct surface
All orders for spare parts SHOULD INCLUDE THE PART CODE AS INDICATED IN THE LIST
OF PARTS. We recommend including the MACHINE SERIAL NUMBER.
The identification plate with the serial numbers and model are located on the upper side of the
engine bed.
Provide correct transport instructions, including preferred route, and consignee's full name and
address.
Spare parts should not be returned to the factory unless permission has been granted in
writing by them. All authorised returns should be sent carriage paid.
The guarantee is valid for 1 year as from the purchase of the machine. The guarantee will
cover parts with manufacturing defects.
The guarantee will not, under any circumstances, cover a fault due to incorrect use of the
equipment.
In all guarantee requests THE MACHINE MUST BE SENT TO ENARCO, S.A. or
AUTHORISED WORKSHOP, always indicating the consignee's full name and address.
The Technical Assistance Service department will immediately inform if the guarantee is
accepted and, if requested, a technical report will be sent.
No type of guarantee will be applicable to any equipment that has previously been manipulated
by personnel not attached to ENARCO, S.A.
VIBRATING PLATES