Mounting Opener To Ceiling - Craftsman 200.57983 Manual Del Propietário

Mounting Opener to Ceiling

To prevent SERIOUS INJURY or DEATH:
- DO NOT connect power until instructed.
- Install the opener at least 7 feet (2.13m) above the floor.
- Fasten the opener SECURELY to STRUCTURAL SUPPORTS of the garage to prevent falling.
- If installing brackets to masonry, concrete anchors (not provided) MUST be used.
Fig.1
Finished ceiling
Fig.2
Finished ceiling
Fig.3
!
Angle Iron not provided
Bolt / Lock Washer / Nut
not provided
Angle Iron not provided
Bolt / Lock Washer / Nut
not provided
WARNING
To Mount the Opener to Ceiling
The three most common installation options are shown in
Fig.1-3.
Fig.1 shows mounting the opener directly to structural
support on the ceiling. Fig.2 and 3 show mounting on a
finished ceiling, with heavy duty angle iron*.
*(angle iron not included)
Determine the mounting option that works best for your
application and follow installation steps below:
1. Raise the opener and rail assembly and temporarily place it
on a stepladder.
2. Position the opener and rail assembly so that it is aligned to
the center line of the garage door. If the header bracket was
mounted off center, align the opener with the header
bracket.
3. Measure the distance from each side of the opener to the
structural supports.
4. Cut both hanging brackets to appropriate length.
5. Drill 3/16" holes in the structural supports.
6. Secure one end of each of the hanging brackets to the
structural supports
(provided).
7. Secure the opener to the hanging brackets and secure each
side with a 5/16" x 1" bolt and flange nut (provided).
8. Move the door manually to check clearance between
highest point of travel of the door and rail. If the door hits the
rail, raise the header bracket or adjust the mounting of
opener.
9. Remove the ladder ONLY when the opener is securely
mounted to the structural supports.
Fastening Hanging Brackets to structural supports
Securing Opener to Hanging Brackets
Flange Nut
using 5/16" x1-1/2"
Lag Screw 5/16" x 1-1/2"
Bolt 5/16" x 1"
lag screws
11