Travel Limit Adjustment- I. Up Limit - Craftsman 200.57983 Manual Del Propietário

Travel Limit Adjustment— I. UP Limit
To prevent SERIOUS INJURY or DEATH from improper Force Adjustment:
- YOU CANNOT adjust force manually to compensate for binding or sticking of the garage door. Call a
qualified garage door service person to make necessary adjustments in case of binding.
- YOU CANNOT manually increase the force required for closing the door.
- After ANY adjustments, Safety Reverse Test MUST be performed to ensure the door reverses on contact
with a 1.5" high object (2x4 laid flat).
NOTICE: This opener will not work until you set the travel limits and the auto
force adjustment. You must follow all steps on pages 18,19,20.
I. Setting UP Limit
1
UP
DOWN
2
FORCE UP
UP
LIMIT
DOWN
Press & Hold Up
* DO NOT HIT STOP BOLT *
3
Minimum 2" (5cm) clearance
Stop Bolt
Trolley
5
Desired UP limit
Press & Release
18
FORCE UP
DOWN
LIMIT
x1
Press & Release
OK
Flashes and off
FORCE UP
UP
LIMIT DOWN
DOWN
x1
WARNING
!
About Travel UP Limit Adjustment
Travel "UP" Limit Adjustment regulates the fully-open (UP limit)
position. This step will program how far the opener will open the
garage door.
Make sure the trolley is engaged, photo eyes are installed
P.15 and photo eyes are aligned P.17 before proceeding
with adjustments.
I. Setting Travel UP Limit
1. Press and Release "LIMIT" button ONCE to enter Travel
Limit Adjustment. "UP" indicator (green) will turn on*.
*NOTE: Once you have pressed and released the "Limit"
button, the "UP" light will stay on for 10 seconds. You
must press & hold the "UP" button within 10 seconds to
begin programming. If the "UP" light turns off before
pressing and holding the "UP" you will need to start over.
2. With green indicator on, press & hold the "UP" button,
the door will travel up. You may use both "UP" or
"DOWN" buttons to inch-adjust the door to the desired
UP limit position.
3. DO NOT HIT STOP BOLT! There is a minimum 2" (5cm)
gap between Trolley and Stop Bolt.
4. Make sure there is enough clearance for your vehicle(s),
to enter and exit the garage door.
5. Once the door is at the desired UP limit position, press
and release "LIMIT" button once, "OK" indicator (orange)
flashes and goes off. The UP limit is set.
Continue to page 19 for down limit