Wiring Instructions - Craftsman 200.57983 Manual Del Propietário

Wiring Instructions

To prevent SERIOUS INJURY or DEATH from electrocution:
- Power MUST NOT be connected until instructed.
- NO exposed part of the wire should be visible outside of the terminal for proper connection.
* VERY IMPORTANT! *
Wire from accessories
Remove and discard pre-cut skin
Right
Fig. 1
Wire Terminals
1
Screwdriver or similar tool
3
Fig. 2
14
!
Wrong
PHOTO EYE PUSH BUTTON
2
1/2"
Wire shown in actual size
WARNING
In the following section, the photo eye safety system and
push button will be connected to the opener. Please read
and understand the wiring instructions before connecting
wires.
1. Remove the pre-cut skin on the open end of wire from
accessories. Wires MUST NOT be frayed. Wires must be
connected as shown in Fig.1.
2. To connect a wire to an assigned terminal, use a small "flat
head" screwdriver to push in the orange tab on the Wire
terminal as shown in Fig.2.
3. Insert approximately 1/2" (13mm) of the wire into the
terminal while pushing in the tab as shown in Fig.2.
4. Each accessory requires a pair of terminals. Each pair of
terminals MUST be connected with one white wire and one
striped wire (non-polarized) from the SAME accessory as
shown in Fig.2.
5. Check for proper connection by gently pulling on the wire.
The wire should not come out of the terminal. NO exposed
part of the wire should be visible outside of the terminal.
6. Use the insulated staples provided to secure the wires to
the wall and/or ceiling. Be careful not to damage the wires
while securing the staples.
Wires to the terminals on the opener
Photo Eye Safety System
Suggested placement of insulated staples
Terminals