Wiring A Door Strike Lock (Normally Open); Wiring A Maglock (Normally Closed) - LiftMaster EL1SS Manual De Instalación Y Configuración

INTRODUCTION

WIRING A DOOR STRIKE LOCK (NORMALLY OPEN)

The door strike can be connected to Relay 1 or
Relay 2 . See the Set Up section for information
INTRODUCTION
about configuring Relays 1 and 2 .
INTRODUCTION
AC or DC Power

WIRING A MAGLOCK (NORMALLY CLOSED)

The maglock can be connected to Relay 1 or Relay 2 . See the Set Up
section for information about configuring Relays 1 and 2 .
INTRODUCTION
INSTALLATION
INSTALLATION
INSTALLATION
Door Strike
NOTE: Do not use the unit's
power supply for the door strike.
NOTE: For AC power install a
Siemens S10K30 MOV
(Metal Oxide Varistor)
or equivalent.
NOTE: For DC power install a 1N4001
diode or equivalent.
AC or DC
Power
INSTALLATION
NOTE: For DC power
install a 1N4001 diode
or equivalent.
NOTE: Capacitor not needed for DC power install.
TEST
TEST
TEST
COM (Common)
NO (Normally Open)
Maglock
TEST
NOTE: Do not use the
unit's power supply for the
maglock.
10
SET UP
SET UP
• Wire connectors can be
removed to simplify
wiring .
• DO NOT overload wire
connectors . Use
ONLY one wire per hole .
SET UP
SET UP
COM (Common)
NC (Normally Closed)