Resident - System Programming Using The House Phone - LiftMaster EL1SS Manual De Instalación Y Configuración

INTRODUCTION

RESIDENT - SYSTEM PROGRAMMING USING THE HOUSE PHONE

A house phone is a telephone with an actual wiring connection to the EL1SS system . See call forwarding instructions on page 17 .
PROGRAM DESCRIPTION OF FUNCTION OR SETTING
NUMBER
**01 ENABLE CALL FORWARDING
Factory Setting: Disabled
NOTE: This setting requires the system to be connected to the residence's
phone line and Telco Mode to be enabled (see page 14).
**02 DISABLE CALL FORWARDING
**03 ENABLE INTERCOM MODE
Factory Setting: Disabled
**06 VERIFY CALL FORWARDING NUMBER (VIA CALLER ID)
Factory Setting: Disabled
**07
ENABLE TELCO MODE
Factory Setting: Enabled
**#8 ERASE CALL FORWARDING NUMBER
NOTE: This command will also disable the call forwarding mode.
**10
ADJUST "PICK UP" RING COUNT
Factory Setting: 5
**13 ENABLE ALTERNATE DTMF (DUAL TONE MULTI FREQUENCY)
PROGRAMMING
This feature changes the leading programming digits from ** to ## (and
*# to #*) to work around phone lines (or telephone equipment) that reacts
to the * tone .
Factory Setting: Disabled
NOTE: The telephone line should be disconnected while entering this
INTRODUCTION
command.
**14 ENABLE STANDARD (LONG) RING TONE
Factory Setting: Enabled
**15
ENABLE ALTERNATE (DUAL) RING TONE
Factory Setting: Enabled
NOTE: Alternate ring tone function may not work with all phones
#*16
DISABLE ALTERNATE DTMF PROGRAMMING
*# Call ENTER CALL FORWARDING TELEPHONE NUMBER
Forwarding
Number #
INSTALLATION
INSTALLATION
TEST
PROGRAMMING STEPS
**01
**02
**03
**06
Hang up the phone - Wait for the ring .
**07
**#8
**10
**13
TEST
**14
**15
#*16
*# +
16
SET UP
+ Ring Count 2 through 5
SET UP
Telephone Number (Up to 14 digits) + #