Included In The Kit; Battery Installation; Refill Replacement; Tip Replacement - Walter Surfox 54-T 011 Manual Del Usuario

SURFOX Smart Passivation Tester
TM

2.3 Included in the kit

SURFOX™ SMART PASSIVATION TESTER
1 x Positive validation plate
◆
1 x Negative validation plate
◆
1 x Bluetooth Module
◆
1 x Probe (with cartridge and felt tip)
◆

3. Battery installation

1.
Open the cover of the battery compartment.
2.
Insert/replace the batteries (3 x N 1.5 V).
3.
Close the cover of the battery compartment.
NOTE: 3 batteries are included with the tester.
Do not use rechargeable batteries in the SURFOX™ Smart Passivation

4. Refill replacement

WARNING: Wear gloves during the operation to avoid direct contact between the
electrolyte solution and the skin.
1. Unscrew the cap (6) of the cartridge compartment.
2. Remove and replace the cartridge with a new one.
3. Screw the cap (6) back on the compartment. (Fig. 2)
ATTENTION: Ensure the cap is screwed on properly to avoid any evaporation of the electrolytic solution.

5. Tip replacement

Replace the tip when worn or dirty by following the instructions below.
WARNING: Wear gloves during the operation to avoid direct contact between the
electrolyte solution and the skin.
10
5 x Felt tips
◆
1 x Owner's manual
◆
1 x Carrying case
◆
3 x Type N batteries
◆
Fig. 2