Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
(toe,need>
STEP
8
Adjusting
the Air Adjustment
Shutter
If Necessary
To determine
if the oven burner flames are burning
properly, first remove the oven bottom.
To remove the oven bottom:
I, Remove the knurled
1
"_...k._
the rear of the oven ///
bottom.
2. Grasp the oven
bottom
at the finger
slots on each side.
Oven bottom
3. Lift the rear of the oven bottom
enough
to clear the
lip of the range ftame,
then
pull out.
"With the oven bottom
removed,
properly
c
adjusted
flames should
have approximately
!" (2.5 cm) blue cones
and, if range is
supplied
with
natural
gas, should
burn with
no yellow tipping.
(With
most
LP gas, small yellow
tips at the end of outer
cones are normal.)
Flames
should
not lift off the burner
ports.
If lifting is
observed,
gradually
reduce
air shutter
opening
until
flames are stabilized.
The shutter
for the oven burner
is near the back wall
of the oven and behind
the broiler
drawer. To remove
the broiler
drawer:
1. Pull the drawer out until it stops, then push it back
in about 1" (2.5 cm).
2. Grasp the handle,
lift and pull the broiler drawer out.
Remove the metal
shield at the rear
of the drawer
cavity. The air
adjustment
shutter is behind
this shield_ To
adjust the flow of
air to the burnei,
loosen the
Phillips-head
screw and rotate
the shutter to
allow more or less
air into the burner tube.
Loosen
Metal shield
STEP
9
Leveling
the Range
1. Remove the storage drawer, broiler drawer or ldck
panel,
2, Use a 3/16"
open-end
or
socket wrench
to back out
/"
both rear leveling
legs
approximately
two turns.
3. Use a 1_" open-end
or
adjustable
wrench
to back
out the front leveling
legs
two turns,
/
)
4. Install the oven shelves in
the oven and position
the
range where
it will be installed.
5. Check for levelness
by placing
a spirit level or a
partially
fiUed cup of water
on one of the oven
shelves, If using a spirit level, take two readings--
with the leve! placed
diagonally
first in one direction
and then the other.
6. Adjust
the leveling
legs until the range is level.
7. After the range is level, slide the range away from
the watt so that the Anti-Tip
device can be installed.
38
Publicidad
