Features - Surtek CE716 Manual De Usuario

6. Safety decals are on this machine to warn
and direct you to how to protector yourself
or visitors from personal injury. These decals
MUST be maintained so that they are legible.
REPLACE decals that are not legible.
7. DO NOT leave the unit plugged into the
electrical outlet. Unplug the unit from the out-
let when not in use and before servicing, per-
forming maintenance tasks, or cleaning.
8. ALWAYS turn the power switch OFF before
unplugging the planer.
9. DO NOT handle the plug or planer with wet
hands.
10. USE only accessories as described in this
manual.
11. DO NOT pull the planer by the power
cord. NEVER allow the power cord to come in
contact with sharp edges, hot surfaces, oil or
grease.
12. DO NOT unplug the planer by pulling on
the power cord. ALWAYS grasp the plug, not
the cord.
13. REPLACE a damaged cord immediately. DO
NOT use a damaged cord or plug. DO NOT use
if the planer is not operating properly, or has
been damaged, left outdoors or has been in
contact with water.
14. DO NOT use the planer as a toy. DO NOT
use near or around children.
15. ENSURE that the machine sits firmly on the
floor before using. If the machine wobbles or
is unstable, correct the problem by using shims
or blocks prior to operation.
16. This machine is designed to process WOOD
ONLY.
17. NEVER position fingers or thumbs near the
infeed roller.
18. Long pieces of stock should ALWAYS be
supported with some type of fixture.
19. DO NOT operate planer with dull or dam-
aged blades.
20. MAKE CERTAIN that the planer is properly
adjusted prior to use.
21. DO NOT try and remove excessive amounts
of wood in one single pass.
22. INSPECT all stock before planing, ensuring
that there are no foreign objects embedded in
the wood, loose knots, or knots that may be-
come loose during operation.
23. DO NOT attempt to remove jams until pow-
er is disconnected and all moving parts have
22
come to a complete stop.
24. MAKE SURE that there is adequate operat-
ing space on both the infeed and outfeed sides
of the planer before operating.
25. DO NOT attempt to plane wood that is less
than 7" long or less than 1/8-inch thick.

FEATURES

KNOW YOUR TOOL
Before attempting to use this chop saw, be-
come familiar with all of its operating features
and safety requirements.
WARNING: Do not allow familiarity with
the hammer drill to cause carelessness.
Remember that a fraction of a second of care-
lessness is enough to inflict severe injury.
KNOW YOUR TOOL
1. MAGNETIC SWITCH.
2. RETURN ROLLERS.
3. TABLE RAISE/LOWER HANDWHEEL.
4. BED ROLLERS.
5. LIFTING HANDLES.
6. ACCESS PANEL
7. BELT GUARD.
2
1
7
MAGNETIC SAFETY SWITCH OPERATION
The magnetic safety
switch as shown as up Fig.
needs to be installed to
under side of the front
rail, see assembly section
in this manual for further
instructions.
3
4
5
6
a
b