Adjustments - Surtek CE716 Manual De Usuario

9. Assembly the either side of both front /
rear roller bracket (e) and do not securing the
screws.
NOTE: The front roller bracket should be as-
sembled on the front side of upper cover and
rear roller bracket should be on the rear side.
10. Assembly both rollers on to roller bracket
then the other side of roller bracket and tight-
en all the screws.
11. Spin rollers (C) by hand to insure that they
move freely.
SWITCH BRACKET ASSEMBLY
1. Find the hardware of 2 M6 x 16mm hex soc
head screws and M6 lock washer for assembly
the switch bracket on the left hand side of cut-
ter head casting.
2. Use 5mm allen
wrench and tighten
the 2 of M6 x 16 mm
hex soc screws (Fig.6).
GEARBOX SHAFT
KNOB ASSEMBLY
Assembly the knob on
to the shaft as Fig.7
showed.
EXTENSION TABLES
The extension table support the workpiece as
it enters and exits the planer.
1. To mount the extension tables, thread three
M8 x 20mm set screws into the bottom holes of
the extension table. Only screw them in about
1/3 of the way for now.
2. Using three M8
x25mm hex head
mounting bolts,
mount one extension
table to the main ta-
ble (Fig.8).
3. Place a straight
edge on the main ta-
ble so that it lies flat
on the table and ex-
tends out over the ex-
tension table (Fig.9).
4. Adjust the three set screws until edge of the
extension table that is the furthest away from
Fig.6
Fig.7
Fig.8
Fig.9
E N G L I S H •
the main table is even with the straight edge.
Please note that it may take several combina-
tions of loosening and/or tightening the set
screws and mounting bolts to get the exten-
sion table level with the main table.
5. Repeat steps 1-4 to attach the other exten-
sion table to the other side of the main table.

ADJUSTMENTS

Some of the adjustments covered in this sec-
tion have already been made at the factory. It
is still a good idea to familiarize yourself with
all of the following procedures so that you
have a solid understanding of the planers op-
eration.
TABLE PARALLELISM ADJUSTMENT
To make adjustments
to the table, it is
necessary to make a
gauge block. When
constructing this
block, be sure to use a
hardwood such as oak
or maple. DO NOT use standard 2x4-inch mate-
rial. A diagram for this block is located near the
end of the manual.
NOTICE: A substitute for this gauge block
would be to use a magnetic dial indicator.
Anywhere it calls for use of the gauge block in
this section, you may substitute with the dial
indicator.
WARNING: DO NOT make adjustments while
the planer is running. Make certain that the
switch is in the off position and that the ma-
chine is disconnected from the power source.
CAUTION: Planer knives are extremely sharp.
Please use extra caution when your hands are
near the blades.
1. Having the table parallel to the cutterhead
is essential for planing stock perfectly square.
Check this by placing the gauge block that you
have constructed under the left end of the cut-
terhead.
2. Turn the handwheel clockwise to raise the
table so that the block barely touches the left
side of the body of the cutterhead.
NOTE: Make sure that the block is actually
touching the body of the cutterhead and not
the knives.
Us er ' s m anual
Fig.10
25