Working Clearances - Surtek CE716 Manual De Usuario

WORKING CLEARANCES

Take into consideration the size of the mate-
rial to be processed, space for auxiliary stands,
work benches, etc. before setting up this ma-
chine. Make sure that you allow enough space
for your machine to operate freely.
OUTLET PLACEMENT
Outlets should be located close enough to the
machine so that the power cord or extension
cord is not in an area where it would cause a
tripping hazard. Be sure to observe all electrical
codes if installing new circuits and or outlets.
WARNING: DO NOT assemble the planer un-
til you are sure the tool is not plugged in. DO
NOT assemble the Planer until you are sure the
power switch is in the OFF position. For your
own safety, DO NOT connect the machine to
the power source until the machine is com-
pletely assembled and you read and under-
stand the entire User Manual.
WARNING: This plan-
er is a very heavy piece
of equipment. To as-
sist with moving the
unit, this Planer con-
tains lifting handles
(Fig.1a) that slide out
from the base of the planer head. These han-
dles can be used as lifting points using a fork-
lift or overhead lift. Attempting to lift this unit
without the proper equipment or adequate as-
sistance could result in a serious injury.
HANDWHEEL
The purpose of the handwheel is for raising
and lowering the planer table
1. Locate the hand-
wheel shaft at the
front right corner of
the planer.
2. Insert key (Key is
taped to shaft) into
the keyway on the
handle shaft.
3. Line up the notch in the handwheel with the
key and slide the handwheel onto the handle
shaft.
4. Secure the handwheel using one M12 hex
nut and one M12 flat washer provided.
24
a
Fig.1
Fig.2
5. Screw handle into the threaded hole on the
handwheel (Fig.2).
LOCKING FOOT PEDAL
NOTE: Assembled the
locking foot pedal
assembly on to the
planer before remove
the planer from metal
pallet.
1. Loosen 4 of M6 x 10mm pan head screws re-
move the cabinet front cover for assembly the
locking foot Pedal.
2. Use 2 of M8 x 65mm carriage head screws
assembly the foot pedal on to tube mounting
holes which on the front below position of
cabinet.
3. Assembly both M8 lock washers and tighten
the M8 hex nuts. Replace the cabinet front
cover.
DUST CHUTE
This planer features a 5-inch dust chute for use
with a dust collection system. If this planer is
not to be hooked up to a dust collection sys-
tem, DO NOT attach the dust chute.
1. Assembly the dust
chute on to the left
hinge bracket (Fig.4a)
which assembled on
the back of left side of
cutter head casting.
2. Assembly the right hinge bracket (b) on the
right side of dust port.
3. Use 4 mm allen wrench to tight both of 2
M5 x 12 mm hex soc screws and M5 washers to
secure the right hinge bracket.
4. Unbolt the upper cover from the planer to
allow access to the screw holes.
5. To attach the dust chute, mount the dust
chute above the upper cover on the planer.
6. Line up the 3 holes
on the top of the dust
chute with the 3 holes
on the upper cover
and fasten with three
M6 x 12mm hex head
serrated screws (Fig.5d).
7. Use three M6 x 12mm hex head serrated
screws and fasten the dust chute to the body
of the planer.
8. Rebolt the upper cover to the planer.
Fig.3
Fig.4
a
b
c
d
e
Fig.5