Unpacking; Assembly - Surtek CE716 Manual De Usuario

Cepillo estacionario industrial
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Do not turn the cabinet saw on until all as-
sembly and adjustment instructions have been
done. To start the cabinet saw, press the green
start button (a) and to stop the cabinet saw,
press the red emergency stop button (b).

UNPACKING

IMPORTANT: The machine is heavy, two peo-
ple are required to unpack and lift. Use a safety
strap to avoid tip over when lifting machine.
Check shipping carton and machine for dam-
age before unpackaging.
packaging materials, parts and machine from
shipping carton. Always check for and remove
protective shipping materials around motors
and moving parts. Lay out all parts on a clean
work surface.
Remove any protective materials and coatings
from all of the parts and the jointer. The pro-
tective coatings can be removed by spraying
"Multipurpose lubricant" on them and wiping
it off with a soft cloth. This may need to be re-
done several times before all of the protective
coatings are removed completely.
After cleaning, apply a good quality paste wax
to any unpainted surfaces. Make sure to buff
out the wax before assembly.
Compare the items to inventory figures; verify
that all items are accounted for before discard-
ing the shipping box.
WARNING: If any parts are missing, do not
attempt to plug in the power cord and turn
"ON" the machine. The machine should only
be turned "ON" after all the parts have been
obtained and installed correctly.
a. Dust chute.
b.Extension wings
(front & back).
c. Handwheel.
d. Handle.
e. M12 hex nut.
f. 13 X 28 x 3t flat washer.
g. 12-14mm open end wrench.
h1. 33mm Open end wrench.
h2. 8-10mm Open end wrench.
Carefully remove
a
b
E N G L I S H •
i. 6mm Allen Wrench.
j. 5mm Allen Wrench
k. 4mm Allen Wrench
l. 3mm Allen Wrench
m. 2.5mm Allen Wrench.
n. M6 x 12mm Hex Head Serrated Screw.
o. Knob.
p. M5 x 12mm Hex Soc Hd Screw.
q. 5.2x12x2t Flat Washer.
r. Hinge Bracket Right.
s. M8 x 20mm Hex Soc Set Screw.
t. M10 x 30mm Hex Soc Hd Screw.
u. M10 Lock Washer.
v. 10.2x21x2t Flat Washer.
w. Locking Foot Pedal.
x. M8 Hex Nut.
y. M8 Lock Washer.
z. M8 x 65mm Carriage
Hd Screw.
aa. M6 x 16mm Hex Soc
Hd Screw.
ab. Roller.
ac. Rear Roller Bracket.
ad.
Front
Roller
Bracket.

ASSEMBLY

Before beginning assembly, take note of the
following precautions and suggestions.
FLOOR
This tool distributes a large amount of weight
over a small area. Most commercial floors are
appropriate for this unit, however, in residen-
tial use, flooring may need added reinforce-
ment to accommodate the weight of the ma-
chine and operator.
Us er ' s m anual
y
z
x
w
ac
aa
ad
ab
23

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ce720

Tabla de contenido