Plugging In And Removing The Spray Clip For Naci Application - Dentsply Sirona Midwest E Plus Manual Del Operador

5 Operation
5.3 Plugging in and removing the spray clip for NaCI application
12
5. Then pull and turn the bur instrument to check that it is firmly seated.
Removing the pin
1. Screw in the supplied tool (A).
2. Open the clamping system.
A
3. Pull out the pin.
5.3
Plugging in and removing the spray clip for NaCI
application
Plugging in the spray clip
✔
The spray water supply at the motor or treatment center is turned off.
1. Plug the silicone hose (D) into the tubule on the spray clip for saline
solutions (B/C).
2. Plug the spray clip into the instrument.
Tip: Use the silicone disks (A), to hold back the cooling air emitted from
the instrument from the preparation site and to direct it away laterally.
Removing the spray clip
1. Remove the spray clip from the instrument.
2. Flush out the spray clip and silicone hose with clear water.
Sirona Dental Systems GmbH
Operating Instructions Midwest E Plus
66 04 206 D3686
D3686.201.01.01.02 08.2016