Do Not Use These Cleaning Agents; Troubleshooting - Gaggenau VF 414 610 Manual De Instrucciones

6 Place a heat-resistant bucket (at least 10 liters =
2.65 gallons) under the oil drain valve. Drain
water. Rinse thoroughly with clear water. Close oil
drain valve, screw protective cap back on.
7 Dry deep fryer basin with a soft dishtowel.
Note: The deep frying basin should not be treated
with stainless steel care agents because these are
frequently not neutral as far as foodstuffs are
concerned.
Appliance part/sur- Recommended cleaning
face
Deep fryer basin, heat- Clean with a soft dishwashing
ing element brush and dishwashing liquid and
dry thoroughly with a soft dish-
towel.
Frying basket Dishwasher
Frying basket suspen- Clean with warm water and dish-
sion, stainless steel washing liquid.
cover
Control knobs Clean with a soft, moist cloth and
some detergent; the cloth must
not be too wet.

Troubleshooting

You can often easily eliminate problems that may
occur on your own. Before calling customer service,
take into account the following information.
Malfunction
Appliance does not heat up. Right-hand
illuminated ring flashes fast, left illumi-
nated ring is off.
16

Do not use these cleaning agents

▯
▯
▯
▯
▯
▯
9
Possible cause
Overheating protection: no or too little
oil or fat in the deep frying basin.
Overheating protection: old fat or oil.
Overheating protection: an oil level has
been set although there is fat in the fry-
ing basin.
Appliance was turned on with heating
element folded out.
Safety shut-off: appliance has not been
operated in the past four hours.
Power outage: after a power outage,
the appliance stays switched off for
safety reasons.
Caustic or corrosive cleaners
Acidic cleaners (e.g. vinegar, citric acid, etc.)
Cleaners containing chlorine or large proportions
of alcohol
Baking oven spray
Hard, scratchy dish-washing sponges, brushes or
scourers
Thoroughly wash out new sponge cloths before
using them.
WARNING
Risk of electric shock
Incorrect repairs are dangerous. Repairs may
only be carried out by one of our trained after-
sales engineers. If the appliance is faulty,
unplug the mains plug or switch off the fuse in
the fuse box. Contact the after-sales service.
Solution
Turn off appliance and let it completely
cool down. Fill with oil or fat at least to the
minimum mark.
Turn off appliance and let it completely
cool down. Replace deep frying fat or oil.
Turn off appliance and let it completely
cool down. When using deep frying fat,
set the fat level on the appliance.
Turn off appliance and let it completely
cool down. Swivel down the heating ele-
ment.
Turn the right control knob to 0 and then
switch on again, if necessary.
Turn the right control knob to 0 and then
switch on again, if necessary.