Special Features Of Programmer Mode - Oxypharm NOCOSPRAY 2 Manual Del Usuario

Steps Action
8
EN The programmer will launch and stop the NOCOSPRAY 2 according to
the performed programming.
A beep will sound for 15 seconds before the machine begins to
function.
Leave the room before the end of the 15 seconds.
AT the end of diffusion, a beep will sound.
The device will stop automatically.
4.4.2
In programmer mode, the device cannot be stopped by pressing the
centre of the keypad.
In case of emergency, set the power switch to "0 "or unplug the device.
When the treatment in programmer mode is finished, it is highly recommended to configure the device in
standard mode before switching it off.
Refer to § 4.4.3 below.
If the device is in programmer mode and you switch the device off and
on again, you have 1 minute to change the volume or return to standard
mode.
At the end of this minute, the device will begin to beep in order to signal
the beginning of the treatment.
Leave the room before the end of the 15 seconds.
Steps Action
1
At the end of treatment, if the device is still turned on, the volume may
be modified.
46

Special features of programmer mode

Illustration
15
S
15
S
Illustration