Side Broom Maintenance - American-Lincoln 56515851 Instrucciones De Uso

MAINTENANCE
FIGURE 89
FIGURE 90
FIGURE 91
SIDE BROOM
The side broom (Fig. 89) sweeping angle is not adjustable. However, the height
of the side broom can be adjusted to compensate as the broom becomes worn
from use. Always check and adjust the sweep pattern after changing the side
broom.
ADJUSTING THE SIDE BROOM HEIGHT
Turn the side broom adjustment knob (A) (Fig. 90) to change the side broom
sweep height. Recheck for proper sweep pattern after adjustment.
Turn the adjustment knob counterclockwise to INCREASE the sweep pattern
width.
Turn the adjustment knob clockwise to DECREASE the sweep pattern width.
REPLACING THE SIDE BROOM
Change the side broom (Fig. 91) when the bristles become worn to less than 3
inches length.
1. Park the machine on a smooth level surface, turn key switch to "O" Position
and engage parking brake.
2. Place the side brooms switch in the "UP" position.
3. Remove the lock pin that holds the broom fl ange to the motor shaft.
4. Disassemble the fl ange from the broom by removing the screws that hold
the fl ange to the broom.
5. Assemble the fl ange to the replacement broom and fasten using the
hardware removed.
6. Install the replacement broom on the shaft and insert the lock pin.
ENGLISH / A-43
FORM NO. 56041720 - 7730 - A-43