Baby Jogger city mini 2 Instrucciones De Montaje página 11

FRAME
1 Unpack the pushchair frame from the
box and set the wheels aside.
Unlock the pushchair by pulling the
auto-lock lever.
2 Unfold the pushchair by pulling the
handlebar away from the frame. Then
lift the handlebar away from the seat.
The pushchair will lock into place and
you will hear a click.
3 Place the pushchair in the upright
position.
WARNING: Ensure that all the locking
devices are engaged before use.
FRONT WHEEL
4 Installation
• Lay pushchair on its back so the
handlebar is resting on the floor.
• Attach the front wheel by sliding it into
the front wheel mount until it clicks.
Gently pull on the front wheel to make
sure it is properly attached.
5 Removal
• While pressing the front wheel release
button, gently slide the front wheel out
of the front wheel mount.
SWIVEL FEATURE
6 Push the swivel lock button down to
lock the front wheel to a fixed position.
7 Press the swivel lock button up to allow
the front wheel assembly to swivel.
WARNING: When loading and
unloading child, lock the front wheel
in a fixed position. Although the front
wheel of your pushchair locks, it is
not intended for jogging or exercise
purposes.
REAR WHEELS
8 Installation
• Align the rear wheel axle with the
wheel mount on the pushchair frame
and insert it into the wheel mount until
it locks into place. You will hear a click.
• Gently pull on the rear wheel to make
sure it is properly attached.
9 Removal
• While pressing down on the wheel
release button, gently slide the rear
wheel out of the wheel mount.
BRAKE
10 To lock the brakes: push the brake
lever down to engage the brakes.
11 To release the brakes: lift the brake
lever up.
WARNING:Lock the brakes before
loading and unloading your child and
whenever the pushchair is not moving.
CANOPY
12 Attach the canopy to the frame by
sliding the canopy onto one of two
mounting brackets. To remove, slide
canopy off of mounts.
NOTE: When using a City Go i-Size/
Graco or Britax car seat, the canopy
must be in the top position. For all
other carseats, canopy must be
removed.
13 Snap the two snaps to the pushchair
frame.
14 Zip the back of the seat to the canopy
top. Attach the 2 fastening strips on
the side of the canopy.
15 Pull forward to open canopy and push
backwards to close canopy.
16 There are two canopy windows, a top
one and back one. To use them, roll
the shade up towards the top and
secure with the elastic and button.
ADJUSTING SAFETY HARNESS
17 From the back of the seat, undo the
fastening strip and open the pocket to
locate the plastic square stopper. Turn
stopper and pass through the openings
in the PE board and seat fabric.
18 Reinsert stopper at seat opening
closest to child' s shoulders. Pass back
through seat fabric and PE board. Tug
on strap to ensure stopper is locked.
Repeat on both sides.
WARNING: Avoid serious injury from
falling or sliding out. Always properly
adjust and fasten safety harness.
WARNING: Always use the crotch
strap in combination with the shoulder
straps and waist belt.
19 Slide the harness pads up to access
plastic guide on strap.
11
EN