Manual Setting - TFA Dostmann 60.2521 Instrucciones De Uso

TFA_No. 60.2521_Anleitung
Radio-controlled alarm clock with vibrating wristband
Radio-controlled time reception
he time base for the radio-controlled time is a caesium atomic clock
operated by the Physikalisch Technische Bundesanstalt Braunschweig.
It has a time deviation of less than one second in one million years. The
time is coded and transmitted from Mainflingen near Frankfurt via fre-
quency signal DCF-77 (77.5 kHz) and has a transmitting range of
approximately 1,500 km. Changeover from summer time or winter
time is automatic. The quality of the reception depends mainly on the
geographic location. Normally there should be no reception problems
within a 1,500 km radius around Frankfurt.
Please take note of the following:
• The recommended distance to any interfering sources like computer
monitors or TV sets is at least 1.5 - 2 metres.
• Inside ferro-concrete rooms (basements, superstructures), the
received signal is naturally weakened. In extreme cases, please place
the unit close to a window to improve the reception.
• The clock automatically scans the time signal at 3.00 a.m. every day
to maintain accurate timing. If the reception fails, it will repeat
again at 4.00 a.m. 5.00 a.m. and 6.00 a.m. During night-time, the
atmospheric interference is usually less severe and reception is possi-
ble in most cases. A single daily reception is adequate to keep the
accuracy deviation under 1 second.
7. Operation
• Important: Buttons will not function while scanning DCF signal.
• The instrument will automatically quit the setting mode if no button
is pressed for 20 seconds.
• Press and hold the ▲ or ▼ button in the setting mode for fast
running.
22
21.06.2013 9:16 Uhr Seite 12
Radio-controlled alarm clock with vibrating wristband

7.1 Manual setting

• Press and hold MODE button in normal mode for two seconds.
• 24 hr will be flashing on the display.
• Press the ▲ or ▼ button to choose 12 HR (PM appears on the display
after 12h) or 24 HR system.
• Press the MODE button again.
• Press the MODE button to make the settings in the following
sequence: Hours, minutes, year, month/day sequence (American ver-
sion) or day/month (European version), month, day, day-of-week
language, temperature display °C (Degree Celsius) or °F (Degree
Fahrenheit) and DCF reception (ON or OFF) and press the ▲ or ▼
button to adjust it.
• Day-of-the-week language: English (E), German (G) French (F), Spanish
(S) or Italian (I).
• In areas where no DCF 77 time reception (default: ON) is possible,
you can deactivate the DCF time reception (position OFF). The clock
will then work as a normal quartz clock.
• If the DCF reception is activated, the manually set time will be over-
written by the DCF time when the signal is received successfully.
7.2 Setting of the button sound
• Press the MODE button four times in normal mode.
• ON (default) and KT appear on the display.
• Press and hold the MODE button.
• ON will be flashing.
• Press the ▲ or ▼ button to deactivate the button sound.
• OFF appears.
• Confirm the setting with the button MODE.
• The time appears on the display.
23