IMER INTONACATRICE SILENT 300 Manual De Uso, Mantenimiento Y Repuestos página 35

Revocadora
Tabla de contenido

Publicidad

PROBLEMS
THE ENGINE DOES
FLAT BATTERY
NOT START
THE MIXER STOPS
- GRILL OPEN
DURING OPERATION
- MIXER TOO FULL OR MATERIAL TOO HARD
- NO PRESSURE IN HYDRAULIC CIRCUIT
(PRESSURE BELOW 180/200 BAR)
THE MACHINE DOES
- DIRTY NOZZLE
NOT START ON
- AIR PRESSURE SWITCH NOT CALIBRATED
OPENING AIR TO THE
SPRAYER
AIR PRESSURE SWITCH NOT CALIBRATED
THE MACHINE DOES
NOT STOP WHEN THE
AIR IS CLOSED
MIXER BLOCKED
MATERIAL TOO DRY
(OIL PRESSURE
GAUGE AT 200 BAR)
AGITATOR PUMP
CLAMP TOO TIGHT
BLOCKED
(OIL PRESSURE
WORK PRESSURE TOO HIGH
GAUGE AT 250 BAR)
THE MATERIAL DOES
PIPE OBSTRUCTED
NOT PASS THROUGH
THE SPRAYER
NOZZLE
ENCRUSTED MATERIAL ON HEAD OBSTRUCTING THE
PASSAGE
CLAMP NOT PROPERLY ADJUSTED
DURING OPERATION,
THE DIAMETER OF THE NOZZLE OR DEFLECTOR IS TOO
THE MATERIAL TENDS
LARGE
TO DRIP FROM THE
SPRAYER
DURING WORK, THE
BENT AIR HOSE OR SPRAYER NOZZLE BLOCKED
MATERIAL REACHES
THE SPRAYER
UNEVENLY
IMER INTERNATIONAL S.p.A.
PLASTERING MACHINE SILENT 300, SILENT 300A
CAUSES
35
CURES
CHARGE/REPLACE THE BATTERY
- CLOSE THE GRILL
- ADD WATER TO THE MIX
- CHECK THE SETTING OF THE PRESSURE RELIEF VALVES
ON THE DISTRIBUTOR: THIS OPERATION MUST BE CARRIED
OUT BY QUALIFIED PERSONNEL
- CLEAN THE NOZZLE
- CHECK THE SETTING OF THE PRESSURE RELIEF VALVES
ON THE DISTRIBUTOR: THIS OPERATION MUST BE CARRIED
OUT BY QUALIFIED PERSONNEL
- CHECK THE SETTING OF THE PRESSURE RELIEF VALVES
ON THE DISTRIBUTOR: THIS OPERATION MUST BE CARRIED
OUT BY QUALIFIED PERSONNEL
ADD WATER TO THE MIX
- LOOSEN THE CLAMP SCREWS
- MODIFY THE MIX, REDUCE THE LENGTH OF THE PIPES,
OR USE LARGER DIAMETER PIPES
- POOR MIX, MODIFY IT
- PAUSE TOO LONG, REDUCE THE PAUSE TIMES
- CLAMP NOT CORRECTLY ADJUSTED, CORRECTLY
ADJUST IT
- CLEAN THE DEFLECTOR AND SPRAYER, IF NECESSARY
- ADJUST THE CLAMP
REPLACE THE DEFLECTOR AND/OR NOZZLE WITH ONE OF
SMALLER DIAMETER
MAKE SURE THE AIR HOSE AND NOZZLE ARE FREE

Publicidad

Tabla de contenido
loading

Tabla de contenido