Assembly And Adjustments; Rip Fence Alignment; Rip Fence Pointer Adjustment - Skil 3601 Instrucciones De Funcionamiento Y Seguridad

SM 2610029990 06-13_3601 6/21/13 12:16 PM Page 12
To reduce the risk of injury, never
W RNING
connect plug to power source outlet
until all assembly steps are completed.

Rip fence Alignment

See figure 1.
1. Loosen fence locking knob.
2. Using a phillips screwdriver, loosen the two screws of the
fence alignment plate.
3. Adjust fence until it is aligned with two corresponding
indicator marks.
4. Tighten fence locking knob.
5. Re-tighten both screws on fence alignment plate.

Rip fence pointer Adjustment

See figure 2.
The distance of the fence from the blade when ripping is
determined by lining the pointer with the desired dimension
on the scale.
To adjust the rip fence pointer:
1. Loosen fence locking knob.
2. Slide fence to a specific length (example: 4").
3. Tighten fence locking knob.
4. Using a scrap piece of wood, make a small cut.
5. Measure your cut. If needed, adjust the fence until your
cut equals your desired length (4").
6. Loosen pointer adjustment screw
7. Align pointer to mark on scale (4").
8. Re-tighten pointer adjustment screw.

Assembly and Adjustments

12.
fence
locking Knob
fence Alignment
plate Screws
FIG. 1
Align fence to
indicator marks
FIG. 2
Align pointer
to mark
pointer
adjustment
screw