Rip Cutting - Skil 3601 Instrucciones De Funcionamiento Y Seguridad

SM 2610029990 06-13_3601 6/21/13 12:16 PM Page 19
RIPPING is known as cutting a piece of wood with the grain,
or lengthwise.
RIPPING is performed using the RIP FENCE together with
the PUSH STICK.
A push stick is included with your flooring saw. If your push
stick has become lost or damaged, you can make a push
stick using a piece of 1 x 2, as shown in figure 18.
Use a push stick whenever the fence is 1-3/4 inches or
more from the blade. Use a scrap wood piece when the
operation is too narrow (less than 1-3/4") to allow the use of
a push stick.
Both a push stick or scrap wood piece should be used in the
place of the user's hand to guide the material only between
the fence and blade.
When using a push stick or scrap wood piece, the trailing
end of the board must be square. A push stick or scrap
wood piece against an uneven end could slip off or push the
work away from the fence.
For your own safety, always observe the following safety
precautions in addition to the safety instructions on Pages
2-6.
Never make these cuts FREEHAND (without using the rip
fence because the blade could bind in the cut and cause a
KICKBACK.
Always lock the rip fence securely when in use.
Frequently check the action of the ANTIKICKBACK PAWLS
by passing the workpiece alongside of the spreader while
saw is OFF.
Pull the workpiece TOWARD you. If the PAWLS do not DIG
into the workpiece and HOLD it, the anti-kickback pawls
must be REPLACED. See "Maintenance" on Page 20.
Do not stand directly in front of the blade in case of a
KICKBACK. Stand to either side of the blade.
Keep your hands clear of the blade and out of the path of
the blade.
operation

Rip cutting

FIG. 18
1-1/2
WORKPIECE
1/4
1/4
END
1/4
If the blade stalls or stops while cutting, TURN SWITCH
OFF before attempting to free the blade.
Do not reach over or behind the blade to pull the workpiece
through the cut ... to support long or heavy workpieces ... to
remove small cut-off pieces of material or FOR ANY
OTHER REASON.
Do not pick up small pieces of cut-off material from the
table. REMOVE them by pushing them OFF the table with a
long stick. Otherwise they could be thrown back at you by
the front of the blade.
Do not remove small pieces of cut-off material that may
become TRAPPED inside the blade guard while the saw is
RUNNING. THIS COULD ENDANGER YOUR HANDS or
cause a KICKBACK. Turn the saw OFF. After the blade has
stopped turning, lift the guard and remove the piece.
If workpiece is warped, place the CONCAVE side DOWN.
This will prevent it from rocking while it is being ripped.
19.
3/4
1
15
45° NOTCH