12 Volt Trigger Outlet; Troubleshooting; Power Indicator Is Not Lit; Fuse Replacement - Rotel RC-06 Manual De Instrucciones

12 Volt Trigger Outlet

Some audio components can be turned on
automatically when they receive a 12V turn
on "signal". The 12V Trigger Outputs of the
RC-06 provide the required signal. Connect
compatible components to the RC-06 with a
conventional 3.5mm miniplug cable. When the
RC-06 is in Standby mode, the trigger signal
is interupted, so the components controlled by
it are turned off.

Troubleshooting

Most difficulties in audio systems are the result
of incorrect connections, or improper control
settings. If you encounter problems, isolate the
area of the difficulty, check the control settings,
determine the cause of the fault and make the
necessary changes. If you are unable to get
sound from the RC-06 refer to the suggestions
for the following conditions:

Power Indicator Is Not Lit

The Power Indicator should be lit whenever the
RC-06 is plugged into the wall power outlet. If it
does not light, test the power outlet with another
electrical device, such as a lamp. Be sure the
power outlet being used is not controlled by
a switch that has been turned off.

Fuse Replacement

If another electrical device works when plugged
into the power outlet, but the Power Indicator
of the RC-06 does not light when plugged into
the same outlet and the Power Switch is pushed
in, it indicates that the internal power fuse may
have blown. If you believe this has happened,
contact your authorized Rotel dealer to get the
fuse replaced.

No Sound

Check the signal source to see if it is function-
ing properly. Make sure the cables from the
signal source to the RC-06 inputs are con-
nected properly. Be sure the Function Control
and Monitor Control are properly set. Check
the wiring between the RC-06 and the power
amplifier. Be sure the power amplifier is on
and the speakers are properly connected. If
the power amplifier has level controls be sure
they are set properly.
9
t
Specifications
Total Harmonic Distortion (20 Hz-20 kHz)
Intermodulation Distortion (60 Hz : 7 kHz, 4:1) < 0.004% at 1V output
Frequency Response
Phono Input (MM)
Line Level Inputs
Input Sensitivity / Impedance
Phono Input (MM)
Line Level Inputs
Input Overload
Phono Input (MM)
Line Level Inputs
Output Level / Impedance
Usable Headphone Impedance
Signal to Noise Ratio (IHF "A" weighted)
Phono Input (MM)
Line Level Inputs
Power Requirements
USA Version
European Version
Power Consumption
Dimensions (W x H x D)
Front Panel Height
Weight (net)
All specifications are accurate at the time of printing.
Rotel reserves the right to make improvements without notice.
< 0.004%
20Hz-20kHz, ±0.5dB
4Hz-100kHz, ±3dB
1.2mV / 68 kOhms
150 mV / 24 kOhms
160mV
5V
1 V/ 100 Ohms
8 - 2,000 Ohms
70 dB
100 dB
120 Volts, 60 Hz
230 Volt, 50 Hz
10 Watts
437 x 72 x 328 mm
17 1 / x 2 7 / x 12 15 / "
8 8 16
60mm
4.3 kg, 9.5 lbs.
English