Technical Characteristics - Coleman 9963 Serie Instrucciones De Uso

Parrilla de mesa de propano
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING
• This product is fueled by propane
gas. Propane gas is invisible,
odorless, and flammable. An odorant
is normally added to help detect
leaks and can be described as a
"rotten egg" smell. The odorant can
fade over time so leaking gas is not
always detectable by smell alone.
• Only cylinders marked "propane"
must be used.
• Use only propane gas set up for
vapor withdrawal.
• Propane gas should be stored
or used in compliance with local
ordinances and codes or with ANSI/
NFPA 58. Turn off propane and
disconnect cylinder when not in use.
• Cylinders must be stored out of
reach of children.
CALIFORNIA PROPOSITION 65:
WARNING: This fuel, and by products
of combustion of this fuel, contain
chemicals known to the state of
California to cause cancer, birth defects,
or other reproductive harm.
WARNING
BURN HAZARD
• Never leave grill unattended when
hot or in use.
• Keep out of reach of children.
CAUTION
SERVICE SAFETY
• Keep all connections and fittings
clean. Inspect propane cylinder and
grill propane connections for damage
before attaching.
• During set up, check all connections
and fittings for leaks using soapy
water. Never use a flame. Bubbles
indicate a leak. Check that the
connection is not cross-threaded and
that it is tight. Perform another leak
check. If there is still a leak, remove
the cylinder and contact Coleman for
service or repairs.
• Use as a cooking appliance only.
Never alter in any way or use with
any device or part not expressly
approved by Coleman.
• Clean grill frequently to avoid
grease accumulation and possible
grease fires.
Technical
Characteristics
Input: 8,500 BTU/h
Category: Pressure regulated propane
Fuel: 16.4 oz. disposable propane
cylinders
Regulator: Illida Global Model 666
To Set Up
CONSUMER NOTICE: These assembly
instructions are designed for more than
one grill model. Some features and
components shown may not be included
with your grill.
■ Remove components from carton.
(Fig. 1)
• Table Top Grill
• Grill Grate
• Regulator Assembly
• Grease Pan
• Screws (4)
■ Assemble feet to grill body. Align
screw holes on feet with holes on grill,
install the screws through the inside
of the grill body. (Fig. 2) Tighten the
screws with a Phillips screwdriver.
■ NOTE: Keep grill feet on leveled
surface while installing the feet. Take
care to not over-tighten the screws.
English - 5
Fig. 1
Fig. 2

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido