Use; Standard Operation; Operation With An Somfy Io Sensor; Information Feedback - SOMFY SGH io Guía Instalador

SGH io
6.

USE

6.1.

Standard operation

6.1.1. Favourite position (my)
Definition
A specific position of the tilted slats, referred to as the "favourite position (my)", other than the slats flat
position, is preprogrammed in the motor.
To modify the favourite position (my), see chapter "Additional settings".
Using favourite position (my):
- When the roller shutter is stopped, briefly press the "my"
button: the roller shutter moves to the orientation zone and
stops at the favourite position (my).
6.1.2. STOP function
The roller shutter is moving.
- Briefly press the "my" button: the roller shutter stops
automatically.
6.1.3. Up and Down buttons
Pressing and holding the Up or Down button 0.5 seconds
causes the roller shutter to move up or down completely.
6.2.

Operation with an Somfy io sensor

6.2.1. Operation with an Somfy io sun sensor (type Sunis WireFree™ io)
Refer to the corresponding guide.
6.3.

Information feedback

After each order, the SGH io sends back a message. This information is managed by the io bidirectional
control points.
7.

ADDITIONAL SETTINGS

7.1.

Favourite position (my) of tilted slats

7.1.1 Modification of the favourite position (my)
1) When the roller shutter is stopped, briefly press the "my"
button: the roller shutter moves to the orientation zone
and stops at the favourite position (my).
2) Briefly press the Up or Down buttons to orient the roller
shutter's slats to the desired favourite position (my).
If the same button is pressed briefly several times in
succession, the motor orients the slats based on how
many times the button was pressed.
3) Press the "my" button until the roller shutter makes
a movement: the favourite position (my) has been
programmed.
7.2.

Adding/Deleting Somfy io control points and io sensors

Refer to the corresponding guide.
14
0,5 s.
1
2
3
Copyright © 2010 Somfy SAS. All rights reserved.
my
0,5 s.
my
ou