Power Supply Cord; Electric Dryer Electrical Connections - Whirlpool CGT9100GQ Instrucciones De Instalación

Electrical Connection Options
If your location has:
4-wire receptacle
(NEMA Type 14-30R)
3-wire receptacle
(NEMA type 10-30R)
4-wire direct
3-wire direct
* If local codes do not permit the connection of a cabinet-ground conductor to the neutral wire, go to "Optional, 3-wire connection" section.

Power Supply Cord

1. Disconnect power.
2. Remove the hold-down screw and terminal block cover.
D
C
B
A
3. Install power supply cord strain relief.

ELECTRIC DRYER ELECTRICAL CONNECTIONS

And you will be connecting to:
A UL Listed,
120/240 volt minimum, 30 amp
dryer power supply cord*
A UL Listed,
120/240 volt minimum, 30 amp
dryer power supply cord*
A fused disconnect
or circuit breaker box*
5"
(127 mm)
A fused disconnect
or circuit breaker box*
3½"
(89 mm)
A. Neutral ground wire
B. External ground
conductor screw
C. Center terminal
block screw
D. Terminal block cover
and hold-down screw
Power supply cord strain relief:
n Remove the screws from a 3/4" (19 mm) UL Listed
strain relief. Put the tabs of the two clamp sections into
the hole below the terminal block opening so that one
tab is pointing up and the other is pointing down, and
hold in place.
Tighten strain relief screws enough to hold the two clamp
sections together.
n Put power supply cord through the strain relief. Be
sure that the wire insulation on the power supply
cord is inside the strain relief. The strain relief should
have a tight fit with the dryer cabinet and be in a
horizontal position. Do not further tighten strain relief
screws at this point.
Go to Section
Power supply cord,
4-wire connection
Power supply cord,
3-wire connection
Direct wire,
4-wire connection
Direct wire,
3-wire connection
A
A. Strain relief tab
pointing up
B. Hole below terminal
B
block opening
C. Clamp section
C
D. Strain relief tab
pointing down
D
23