Whirlpool CGT9100GQ Instrucciones De Instalación página 27

ELECTRIC DRYER ELECTRICAL CONNECTIONS
Direct wire,
4-wire connection:
IMPORTANT: A 4-wire connection is required where
local codes do not permit the use of 3-wire connections.
Direct wire cable must have 5 ft (1.52 m) of extra length
so dryer can be moved if needed.
Strip 5" (127 mm) of outer covering from end of cable,
leaving bare ground wire at 5" (127 mm). Cut 1½" (38 mm)
from three remaining wires. Strip insulation back 1"
(25 mm). Shape ends of wires into a hook shape.
When connecting to the terminal block,
place the hooked end of the wire under the
screw of the terminal block (hook facing
right), squeeze hooked end together, and
tighten screw, as shown.
1. Remove center terminal block screw.
2. Remove neutral ground wire from external ground
conductor screw. Connect neutral ground wire
and place the hooked end (hook facing right) of
the neutral wire (white or center wire) of direct wire
cable under the center screw of the terminal block.
Squeeze hooked ends together. Tighten screw.
A
A. External ground conductor screw – Dotted line shows position
of NEUTRAL ground wire before being moved to center terminal
block screw.
B. Center terminal block screw
C. Neutral ground wire
D. Neutral wire (white or center wire)
E. 3/4" (19 mm) UL Listed strain relief
3. Connect ground wire (green or bare) of direct
wire cable to external ground conductor screw.
Tighten screw.
A
B
C
A. External ground conductor screw
B. Ground wire (green or bare) of direct wire cable
C. 3/4" (19 mm) UL Listed strain relief
D. Center terminal block screw
E. Neutral ground wire
F. Neutral wire (white or center wire)
4. Place the hooked ends of the other direct wire
cable wires under the outer terminal block screws
(hooks facing right). Squeeze hooked ends together.
Tighten screws.
B
C
D
5. Tighten strain relief screw.
6. Insert tab of terminal block cover into slot of dryer
E
rear panel. Secure cover with hold-down screw.
7. You have completed your electrical connection.
D
E
F
27