Troubleshooting - SRAM Quadq Manual Del Usuario

Tabla de contenido

Idiomas disponibles

T R O U B L E S H O O T I N G

Performing a Self-Test can quickly diagnose problems with the Power Meter.

Perform a Self-Test by back-pedaling several times, and then observe the LED.

• No flash: Dead battery, or magnet not installed.

• 1 flash: Self check pass. Head unit paired.

• 2 flashes: Self check pass. No head unit paired.

• 3 flashes: Self check Fail. Reed switch Failure.

• 4 flashes: Self check Fail. Bad Strain Gauge.

Power Meter does not pair with the computer

• Check the battery. The battery must be installed correctly ("+" out) and have sufficient charge. Make sure the

battery contact is free of corrosion.

• Check the magnet position. Confirm the magnet is within 2-8 mm (1/16"-3/8") of the sensor. The magnet

should be installed according to the instructions on pages 8-10. Once the cadence sensors have been

activated, the power meter will begin transmitting messages and is ready to be paired.

• Make sure the proper pairing technique has been followed for your bike computer. The pairing process will

vary by manufacturer. Refer to your bike computer's instruction manual.

• If you are using a Garmin

when you are wearing the heart rate monitor/strap. Turn off the ANT+ HRM function if you are not using a

heart rate strap.

• Check with Quarq for the recommended firmware version for your Garmin computer. Follow the instructions

specific to your ANT+™ computer to check the installed firmware version.

G A R M I N E D G E ® 5 0 0 & 8 0 0

Menu → Settings → About Edge

G A R M I N E D G E ® 5 1 0 & 8 1 0

Settings X

→ System → About

To view the menu, you must press and hold the Menu button until the menu pops up.

G A R M I N E D G E ® 1 0 0 0

Menu → Settings → System → About