Bb Cup Mount Installation - SRAM Quadq Manual Del Usuario

B B C U P M O U N T I N S T A L L A T I O N
The BB Cup Mount is only compatible with threaded bottom brackets. It does not work with frames that have
bearings pressed into the bottom bracket (BB30, PF30, etc.). Frames using threaded bottom bracket adapters
(ie. SRAM GXP30 BB Adapter) may use the BB Cup Mount if the mount is installed onto the threaded drive side
bottom bracket cup.
1. If necessary, remove the existing cranks and bottom bracket.
2. Slide the BB Cup Mount over the threads of the drive side bearing cup with the magnet facing away from the
frame.
3. Hold the magnet at the 9 o'clock position while the bottom bracket is tightened to the manufacturer's
recommended torque.
4. Confirm the magnet is within 2-8 mm (1/16"-3/8") of the sensor.
8

BB Cup Mount InstallatIon

2-8 mm
(1/16"-3/8")