Publicidad
Idiomas disponibles
Idiomas disponibles
Remove the 2 screws on the bottom
of the front cover marked number 24
on the previous pages quick guide
this will reveal the main wiring area.
PCU 12V 10A & 20A models have ring
terminal screw connectors as depicted above.
N.B. the 10A model has only 2 outputs, all
other models have 3 outputs.
Remove the 2 screws on the AC area and the 3 screws on
the DC clamps to enable the appropriate wires to
be attached. AC input 80-270V.
Ensure secure connections and correct crimping
tools are used.
DC 12V / 24V / 36V / 48V depending on unit.
Remote control
Insert the Sterling remote control
into the remote socket (telephone type)
Please note that when the remote is inserted the
front program controls on the local panel no longer
operate, control is in the remote. Remove the
remote to use local controls.
Battery Temperature sensor
Connect the battery temp
sensor to the position
as shown, connect the
sensor end to the negative stud
terminal on one of the batteries
which you think will be in the hottest environment.
When the temp. drops the charging voltage goes up incrementally.
When the temp. increases the charging voltage goes down incrementally.
198 mm 7 3/4 inch
12V 10-40A
24V 20A
215 mm
8 ½ inch
High Voltage
AC cover plate
and clamp
Remote control
Live
Neutral
Earth ( European )
Live
Neutral Ground ( USA )
3
7
4 [198]
ProMariner
12V 50-60A
Pro Nautic iQ
24V 30A
12-60
36V 20A
48V 15A
8 1 2 [215]
DC cable clamp
Battery temperature sensor connection
A
1
2
3
Common Negative
red red red
Black (Europe) Yellow (USA)
Pos terminals on
3 x battery banks
dimensions
in inches
and ( mm )
Cut out
90 x 62 mm
FUSES
DC
PCU 12V / 30-60A &
24V 20-30A and 36V / 48V
have bolt terminals as depicted
above, rather than screw.
Publicidad
