Pulsar N450 Manual De Usuario página 10

•
If the indicator lights green continuously, the battery is fully charged. You can
remove the battery from the charger by lifting the lever (С).
•
If the indicator of the charger lights red continuously upon battery installation,
probably the battery's charge level is lower than acceptable (the battery has
been long in deep discharge). Keep the battery in the charger for a long time (up
to several hours), remove and re-insert it. If the indicator starts blinking green,
the battery is good; if it keeps lighting red it's defective. Do not use the battery!
•
Connect the Micro-USB plug of the USB cable to the port (E) of the charger.
•
Connect the Micro-USB plug to the charger.
•
Insert the plug of the charger to the 220V socket.
Installing The Battery Pack:
•
Remove the Battery Pack (6) from the charging base lifting
the lever (C).
•
Raise rilfescope's lever (15). Insert the Battery
Pack (6) into the riflescope as shown with F
element on the Battery Pack facing downwards
(Pic. 5).
•
Fix the battery by clicking rilfescope's lever (15).
Safety measures:
•
Only use the charger supplied with the Battery
Pack. The use of any other charger may irreparably
damage the Battery Pack or the charger and may
cause fire.
•
When keeping the battery for a long period,
the battery should not be fully charged or fully
discharged.
•
Do not charge the battery immediately after
bringing the battery from cold environment to
a warm one. Wait for 30-40 minutes for the battery to get warm.
•
Do not leave a battery unattended while charging.
•
Never use a modified or damaged charger.
•
Charge the Battery Pack at a temperature from 0 °C to +45 °C.
•
Otherwise battery's life will decrease significantly.
•
Do not leave the Battery Pack with a charger connected to the mains longer
than 24 hours after full charge.
•
Do not expose the battery pack to high temperature or to a naked flame. Do not
submerge the battery.
•
Do not connect external device with a current consumption that exceeds
permitted levels.
•
The Battery Pack is brief circuit protected. However, any situation that may
cause short-circuiting should be avoided.
•
Do not dismantle or deform the Battery Pack. Do not drop or hit the battery.
•
When using the battery at negative temperatures, battery's capacity decreases,
this is normal and is not a defect.
•
Do not use the battery at the temperatures above those shown in the table –
this may decrease battery's life. Keep the battery out of the reach of children.
8
3
5
6
Fig.
5
F