Pulsar N450 Manual De Usuario página 24

18 "Sumlight™" Function
•
"SumLight™" function substantially increases sensitivity of the CMOS array thus
enabling observation in low light without using the IR Illuminator.
•
To activate the function SumLight™, press briefly the UP (8) button.
•
To deactivate the function, press briefly the UP button again.
•
Icon "SumLight™" (on S or S off ) is shown in the status bar.
Attention! Upon activation of the SumLight™ function, riflescope's sensitivity
increases which causes an increased noise level in the picture, lower frame rate;
image slows down; if the riflescope rapidly moves from one side to the other, the
picture may be blurred for a moment.
New glowing spots and dots may appear on the display, their brightness and size
may increase.
All mentioned effects are due to the operating peculiarities of the SumLight™
function and are not a flaw of the riflescope.
Important! Please note that due to peculiarities of AMOLED display technology,
when switching between various reticles, you may notice on the riflescope's
display residual "ghost image" of the previous reticle. The "ghost image" looks
like semitransparent white lines. The image may appear if a new reticle does
not contain elements (such as lines, circles, bars etc.) of the previous reticle.
After a while the "ghost image" becomes less noticeable. We do not take any
responsibility for the claims in connection with "ghost image" arisen due to
multiple change of reticles.
19 Video Recording And Photography
The riflescope features video recording and photography of the image being saved
to the internal memory card.
Before using this feature, please read the menu options "Date setup", "Time
setup" of the section "Main menu functions".
The built-in recorder operates in two modes:
Photo (photography; in the top right corner of the display you can see a
photography icon),
If estimated number of photos that can be saved to the Flash card is more than
100, message «>100» is shown.
Video (video recording; in the top right corner of the display you can see a
video icon, current video resolution, total video time left in the format HH:MM:SS
(hours : minutes : seconds)
When switched on, the riflescope is in the Video mode. Toggle between Video
and Photo modes with a long press of the REC (11). Switching is cyclical (Video->
Photo-> Video...).
Photo mode. Photography
•
Switch to the Photo mode with a long press of the REC (11) button.
•
Take a picture with a brief press of the REC button. The image freezes for 0.5 sec
and a photo is saved to the internal memory. Режим Video.
Video mode. Video recording
•
Switch to the Video mode with a long press of the REC (11) button.
•
Start video recording with a brief press of the REC button.
22