Nuova Simonelli MicroBar Instrucciones De Manejo página 70

12.
MACHINE BLOCK ALARM MESSAGES
DISPLAY
UPPER PISTON MOTOR
GROUP ALARMORE
HEATER FILLING
ALARM
TURBINE ALARM
On registering the alarm, the
control unit will display a
message about the drink in
progress with the error mes-
sage correspond-ing to the
function. For example:
WATER TANK EMPTY
ALARM
CAUSE
During the group handling The control unit will halt what-
phase, the upper piston ever cycle is on by turning off
exceeded maximum set time both the movement actuator
by 10 seconds before recog- and those for drink delivery;
nizing motor pickup. the operator will not be able to
make selections on the key-
board.
The heater filling stage has The machine will stop.
exceeded the 3 minute maxi-
mum time; the probe level is
uncovered.
The volume counter will not The delivery will continue for
send any impulses to the con- up to 60 seconds or for as
trol unit for 5 seconds. long as any of the coffee
based drink keys are pressed.
The water tank is empty. The coffee will not be deliv-
ered and the dosing will be
halted while in progress.
EFFECT SOLUTION
Open and close the machine
door.
Open and close the machine
door. The control unit will
repeat the machine starting
up procedure.
Fill the water tank.
NOTE
If the alarm reappears
after the second time of
taying, call the Service
Technician.
If the alarm reappears
after the second time of
taying, call the Service
Technician.
In case the alarm per-
sists, the machine can
be used as a manual
appliance.
• Press the selected
key to start the dos-
ing;
• Once the desired
dose has been deliv-
ered in the cup, press
the same key to halt
the dose being deliv-
ered.
Call the Service
Technician.
Use the Hot Water key
to eliminate any air bub-
bles.
67