Installing The Distal Prosthetic Components - Ottobock 4R111 Instrucciones De Uso

13) Pull one layer of Perlon stockinette over the model.
14) Pull two layers of carbon fibre stockinette over the model.
15) Pull two layers of Perlon stockinette over the model and tie off below the
cap screw of the lamination anchor.
16) Pull on a soaked PVA bag.
17) Perform the casting process with Orthocryl.
18) After the lamination resin has cured, remove the lamination dummy.
5.4 Installing the lamination dummy
Required tools and materials:
>
4X46 lamination dummy
1) Tighten the cap screw of the threaded clamping to a point where the
screwed insert can still be screwed in and out.
2) Unscrew the screwed insert from the lamination anchor.
3) Screw in the lamination dummy.

5.5 Installing the distal prosthetic components

Mounting of a screwed insert
The threaded connector is used for installing a connecting component with
an external thread (e.g. pyramid adapter or prosthetic knee joint).
> Tools required:
710D4 torque wrench, 636K13 Loctite®
1) Screw in the screwed insert (e.g. pyramid adapter) completely into the
thread of the lamination anchor.
2) The screwed insert may be unscrewed by a maximum of 90° out of the
thread in order to align the insert.
3) Secure the cap screw of the threaded clamping using Loctite® and tight­
en using the torque wrench (mounting torque: 10 Nm).
Connecting the pyramid adapter and pyramid receiver
The pyramid adapter is fixed with the set screws of the pyramid receiver.
Required tools and materials:
>
710D4 Torque Wrench, 636K13 Loctite®
1) For definitive mounting:
Use Loctite® to secure the set screws.
2) Screw in the set screws.
3) For trial fitting:
Use the torque wrench to tighten the set screws (10 Nm).
For definitive mounting:
Pre-tighten the set screws with the torque wrench (10 Nm) and then
tighten them (15 Nm).
18 | Ottobock