Care Instructions; Storage Instructions - medi Ankle sport brace Instrucciones De Uso

English
Putting on / taking off
• Undo all straps and loosen the
fastenings of the brace so that you can
place your foot into it easily (Fig. 1)
• Take hold of the top of the brace on
both sides and pull it over your foot
until the heel opening is in the correct
position. The ankle joint should be
centred in the space between the
stabilising shells (Fig. 2)
• Now tie up the brace, going from top
to bottom, as you would a shoe (Fig.3)
• Now take the longer outer strap. Pull it
over the arch of your foot (instep) to
the inside of your foot and then feed it
under the middle portion of the sole of
the foot (Fig. 4)
• Now grip the loop of the strap with a
finger and pull it up the side of your
leg. Fasten the strap slightly above the
ankle joint. When doing this, ensure
that your foot is in a neutral position
(at 90° to your leg) (Fig. 5)
• Now take the inside strap and pull it
over the arch of your foot (instep) to
the outside of your foot and then feed
it under the middle portion of the sole
of the foot (Fig. 6)
• Now grip the loop of the strap with a
finger and pull it up the side of your
leg. Fasten the strap slightly above the
ankle joint (Fig. 7)
• Now do up the belt that goes around
the circumference of the leg (Fig. 8)
• Check that the brace fits snugly and
that you feel stable in it (Fig. 9)
• The brace can be altered or adjusted
according to your requirements at any
time. To achieve this, you can change
the position of or remove the straps
around the heel (Fig.10) and also move
or remove the stabilising shells (Fig. 11)

Care instructions

Please remove the stabilising shells at
the sides and fasten the velcro
fastenings before you wash the brace.
Soap residues, lotions and ointments
can cause skin irritation and material
wear.
• Wash the product by hand, preferably
using a medi clean detergent, or in
delicate cycle at 30°C using a mild
detergent without fabric conditioners.
• Do not bleach.
• Leave to dry naturally.
• Do not iron.
• Do not dry clean.
    

Storage instructions

Keep the product in a cool, dry place and
do not expose to direct sunlight.
Material composition
Polyamide, polyester, polyethylene
Liability
The manufacturer's liability will become
void if the product is not used as
intended. Please also refer to the
corresponding safety information and
instructions in this manual.
Disposal
The product can be disposed of in the
domestic waste.
Your medi team
Wishes you a speedy recovery!