Automatic Mode; Sensor Control; Saturation Display; Lighting - Gaggenau AW 250 Instrucciones De Uso Y Montaje

Automatic mode

Switching on the appliance
#
▯
Press the button.
The fan starts at setting 2.
<
▯
Press the button.
The optimum fan setting 1, 2 or 3 is automatically
set via a sensor.
Switching off the appliance
< #
Press the or button to switch off automatic
mode.
The fan switches off automatically if the sensor no
longer detects a change in the air quality of the room.
The automatic mode lasts 4 hours at most.

Sensor control

In automatic mode, a sensor in the extractor hood
detects the intensity of the cooking and roasting
fumes. Depending on the setting of the sensor, the fan
automatically switches to another fan
setting.Depending on the setting of the sensor, the
fan automatically switches to another fan
setting.Depending on the setting of the sensor, the
fan automatically switches to another fan setting.
Default sensitivity setting: 2
Lowest sensitivity setting: 1
Highest sensitivity setting: 4
If the sensor control responds too quickly or too
slowly, it can be changed accordingly:
1 When the fan is switched off, press the
and hold it for approx. 4 seconds. The setting is
displayed.
2 Press the 1, 2, 3 or
setting of the sensor control.
Button 1 = Sensitivity 1
Button 2 = Sensitivity 2
Button 3 = Sensitivity 3
Ž
= Sensitivity 4
but-
ton
3 To confirm the entry, press and hold the
button for approx. 4 seconds.
20
<
button
Ž
button to change the
<

Saturation display

When the metal grease filters are saturated, a signal
sounds for approx. 4 seconds after the fan is switched
œ
off. The saturation indicator also lights up.
▯
If you have not yet done so, the metal grease
filters should be cleaned now. For instructions on
how to clean the metal grease filters, please refer

Cleaning and maintenance

to the section
▯
While the saturation indicator is lit up, it can be
reset. To do this, press the

Lighting

The lighting can be switched on and off independently
of the ventilation.
@
Press the button.
Setting the brightness
@
Press and hold the button until the desired
brightness is reached.

Audible signal

Switching on the acoustic signal
When the fan is switched off, press the
the same time for approx. 3 seconds. A signal sounds
as an acknowledgement.
Switching off the acoustic signal
Repeat the "Switching on the acoustic signal"
process.
Cleaning and maintenance
m
Risk of burns!
The appliance will become hot during operation,
especially near the bulbs. Allow the appliance to cool
down before cleaning.
m
Risk of electric shock!
Penetrating moisture may result in an electric shock.
Clean the appliance using a damp cloth only. Before
cleaning, pull out the mains plug or switch off the
circuit breaker in the fuse box.
m
Risk of electric shock!
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
m
Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.
.
œ
button.
# Ž
and at