Joovy Qool Manual De Instrucciones página 26

Car Seat Adapter (Graco/Chicco) (Optional)
• To use the car seat adapter in the rear (higher) or middle (lower) position, first ensure the stroller
seat is removed.
• Note where the car seat adapter pieces are labeled "A," "B," "C," and "D."
• Arrange the car seat adapter pieces so that "A" connects to "A," "B" connects to "B," and so on.
(47)
• To assemble, depress the spring pin and slide each adapter piece end into the corresponding tube
on the center bracket until the spring pin clicks into place.
I WARNING:
spring pins have clicked into place. Pull on each adapter piece to be sure
it is securely attached to the center bracket.
• Place the seat brackets at the desired height.
• The car seat adapter can be mounted to enable the car seat to be either forward-facing or rear-
facing. The car seat will face the direction that the arrow diagrams are pointing on each side of the
car seat adapter. (48)
• For the car seat to be mounted forward-facing, orient the car seat adapter so that the arrow
diagrams on the adapter point toward the front of the stroller.
• For the car seat to be mounted rear-facing, orient the car seat adapter so that the arrow diagrams
on the adapter point toward the rear of the stroller.
• Insert the car seat adapter into the seat brackets. (49) Pull on the adapter to ensure it is secure.
• Orient the car seat to face the same direction as the arrow diagrams on the adapter.
• Hold the car seat by the carry handle and lower the car seat onto the stroller so that the hook on
the rear of the car seat latches onto the car seat adapter. (50) Pull up on car seat to ensure it is
secure.
• To remove the car seat, pull the release lever (the same lever used to release the car seat from its
base) and lift up.
• To remove the adapter from the stroller, squeeze upward on both triggers and pull it off the stroller.
(51)
• To use the car seat adapter in the front position, front adapters (sold separately) must be installed
prior to being able to install the car seat adapter. See the Front Adapters section for information on
installation.
• Place the car seat adapter onto both of the front adapters. (52) Pull on the adapter to ensure it is
secure. The car seat adapter can be mounted forward-facing or rear-facing.
• Hold the car seat by the carry handle and lower the car seat onto the stroller so that the hook on
the rear of the car seat latches onto the car seat adapter. (53) Pull up on car seat to ensure it is
secure.
• To remove the car seat, pull the release lever (the same lever used to release the car seat from its
base) and lift up.
• To remove the adapter from the stroller, squeeze upward on both triggers and pull it off the stroller.
(51)
• Before folding, remove any infant car seat. The stroller can be folded with the infant car seat
adapter in place.
I WARNING:
ALWAYS position the infant car seat so that it securely snaps into place
into the infant car seat adapter. Always extend the handle to max. height
when using car seat in the upper rear position. The infant car seat adapter
is for use ONLY with specific car seats. DO NOT use other infant car seat
models that are not in the Car Seat Compatibility List (see page 28). This
product is not a toy. DO NOT allow children to play with it.
26
Before proceeding, be certain that all four
For use ONLY on the Joovy Qool Stroller.