Britax FRONTIER Guia Del Usuario página 10

Installing the Child Seat: Harness Mode
Lap Belt with CLICKTIGHT
Before you begin:
• Check that your vehicle has a seat belt that can be locked.
* Check your vehicle owner's manual to determine what
type of vehicle belt you have and how it can be locked
for use with child seats.
• Check that your vehicle has a top tether anchor.
* The top tether MUST be used in harness mode for
children that weigh more than 65 lbs (29.5 kg). BRITAX
recommends that the top tether be used at all times
when installing the child seat. Using the top tether will
improve the stability of your child seat and reduce the
risk of injury. Check your vehicle owner's manual for
tether anchor locations.
• Loosen the tether and place it over the child seat back to
keep it from becoming pinned between the child seat and
vehicle seat during installation.
• Adjust the child seat to desired position and place forward
facing on the vehicle seat.
Release the buckle and open
1
the CLICKTIGHT.
* Locate the two slots in the
CLICKTIGHT cover.
* Squeeze the CLICKTIGHT
release levers.
14
Installing the Child Seat: Harness Mode
Pull the vehicle belt out and
2
route along the green belt
path. Verify that the belt is not
twisted and then buckle.
Lock and remove slack from
3
the vehicle belt.
IMPORTANT: Only remove
slack from the vehicle seat belt.
Overtightening the belt may prevent
the CLICKTIGHT from properly
securing.
Close the CLICKTIGHT.
4
* A click confirms the
CLICKTIGHT is secure.
* The child seat is secure when
it cannot be moved front-to-
back or side-to-side more than
1 in. (2.5 cm) at the belt path.
If the child seat is not secure,
repeat the installation procedure
or use a different seating
location.
Firmly press the tether hook
5
over a designated vehicle
tether anchor. Remove slack.
Secure excess webbing with
6
the elastic strap
Checklist
9 Check all connections and verify that child seat is secure.
* The child seat is secure when it cannot be moved front-to-
back or side-to-side more than 1 in. (2.5 cm) at the belt path.
If the child seat is not secure, repeat the installation procedure
or use a different seating location.
9 Check that any excess tether webbing is contained within
your vehicle and secured in the elastic strap.
2
OR
OR
15