Booster To Harness Mode: Replacing The Harness And Buckle - Britax FRONTIER Guia Del Usuario

Ocultar thumbs Ver también para FRONTIER:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Switching Between Modes

Booster to Harness Mode: Replacing the Harness and Buckle

Open the CLICKTIGHT.
1
* Locate the two slots in the
CLICKTIGHT cover.
* Squeeze the CLICKTIGHT
release levers.
Unhook the retaining clips at
2
the back of the seat cover. Pull
the seat cover and foam insert
forward.
IMPORTANT: Select the slot
closest to, but not under the child.
Turn and push the buckle
3
retainer through the slot in the
child seat shell.
Pull the EZ-Buckle belly pad
4
through the corresponding
slot in the seat cover. Place
the seat cover back in its
original position and attach
the retaining clips.
Hook the harness straps to the
5
CLICKTIGHT hip anchors.
* Ensure that the harness is
attached to the top of the
hip anchor.
Insert the harness straps
5
through the slots in the cover
and shell, and over the harness
adjuster plate to the back of the
child seat.
34
Nest the harness straps by
7
inserting the right strap loop
into the left strap loop.
Remove the harness yoke
8
from storage underneath the
seat shell and slide the nested
harness straps completely onto
the harness yoke.
Close the CLICKTIGHT.
9
* A click confirms the
CLICKTIGHT is secure.
Buckle the harness and pull
10
the adjuster strap to tighten the
harness.
* Pull the harness adjuster away
from the child seat (parallel to
the ground) to tighten.
IMPORTANT: Check all attachments before using the child seat.
Switching Between Modes
35

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Clicktight

Tabla de contenido